Page is loading ...
1
P.A.SERIES
CDPLAYER/TUNER/CASSETTE/AMPLIFIER
PM8006
PM8012
PM8025
PM8035
OWNER’S MANUAL
Before operating, please read this manual completely．
FEATURES
CD & MP3 Player, Digital Tuner, Full-logic Cassette and Amplifier all in one.
Two Microphone inputs, one AUX input and one AUX output for linking.
Chime function.
Microphone input 1 and Chime out prior to other inputs.
Low / high tone control and volume control available.
Transformer isolated 100V, 70V and 4 Ohms outputs for speaker.
A five-element LED level meter and protective indicator are provided for quick
and easy visual monitoring.
2
FFONT PANEL
1 Power switch 14 Protect indicator 27 CD-Repeat Play
2 Selector- CD 15 VFD 28 CD-Open / Close Door
3 Selector- TUNER 16 TUNER-Band 29 CD-Play
4 Selector- DECK 17 TUNER-Scan high→low 30 CD- Stop
5 Selector- AUX 18 TUNER- Scan low→high 31 CD- Door
6 Chime button 19 TUNER-Memory 32 DECK- Open / Close Door
7 Mic1,Mic2 jacks 20 TUNER-Memo 1→20 33 DECK- Door
8 Mic1,Mic2 volumes 21 TUNER-Memo 20→1 34 DECK- Rewind
9 Bass control 22 CD- Skip down 35 DECK- Fast forward
10 Treble control 23 CD- Skip up 36 DECK- Left Play
11 Main Volume 24 CD-Search down 37 DECK- Right Play
12 Output level meter 25 CD- Search up 38 DECK-Stop
13 Power indicator 26 CD-Pause 39 DECK-Record
Note:
When all the 5 LEDs of level meter remain lit, this indicates that sound is distorted. In such a case, adjust each
volume control so that LED 4 and 5 flash.
REAR PANEL
1 Mains 6 Mute control 11 AUX in Jack
2 AC fuse 7 Chime volume , 12 AUX out Jack
1 2 10 11 12
8
9
4 3 5 6 7
13
4
OPERATION
Press AC POWER button on the rear panel to connect power source and POWER OFF will display on the screen with
rolling form. Then press POWER button on the front panel to turn on the system and WELCOME appears on the screen.
The system will select the Mode the same as you turned off last time in 10 seconds.
1. Play CD / VCD / MP3
Press key CD of selector, and DISC appears on the screen. CD play will start in 1s. or NO DISC appears for indicating
none of CD here.
Disk Load / Unload Press key to open the CD deck, put in or take out a disk and then press key again for
resetting the deck.
Play in Order After the deck reset it will play in order automatically. Press selector key CD as well as the key ,
it will play in order too.
Option Play Press or and or while play, we can select any song or any paragraph for
play.
Play Repeatedly Press key REPEAT once, it will play the song repeatedly. Presses key REPEAT once again, it
will play repeatedly with whole disk. Press key REPEAT the 3rd time for terminating REPEAT.
Pause Press key while play for pause. Press the key again for releasing.
Stop Press key to stop in any time.
2. Radio Receiving
Press selector key TUNER the system will select the Receive Mode with the same frequency as that of the one you turned
off last time. The screen will show the Band and Frequency received.
Band Selecting Press key BAND for switching the band between FM and AM alternatively.
Auto Tune Press key DOWN or UP next to BAND for 1s. to search the radio stations automatically. The screen
will flash until you find a radio station, and shows the frequency digital of the radio station you found. The symbol
of STEREO appears while the radio signal is the form of stereo and the level is high enough.
Fine Tune When the signal is very poor, we need to search the radio station by clicking the key DOWN or UP.
Every time you click, the frequency will be step up or down 50 kHz (FM) or 9 kHz (AM).
Memory After selected a station, press key MEMO with symbol MEM flash. Press M-DOWN or M-UP for
location the memory from CH-01 to CH-20, then press key MEMO again for confirming with symbol MEM
disappears. Note that, in this case the previous value of the memory will be replaced. For call out the memory, just
press down M-DOWN or M-UP to select one of the memories through CH-01 to CH-20.
3. Tape Playing
Press key Tape of the selector to play tape. Clean the magnet head after 10 hours playing so that the voice quality is as
fidelity as possible. After playing for 20-30 hours should delete the magnet by playing magnet-deleting tape.
Insert / Take out Tape Press the symbol OPEN/CLOSE to open the door of deck, insert or take out a cassette
tape and then close it.
Rewinding Press to rewind the tape.
Fast forward Press to forward the tape.
5
Tape playing: Press or to play the tape, after playing one side the system will rewind automatically to
play another side. Press to have it stopped.
Record: Only stop status, press ● to record the tape. you can record from the CD, tuner, AUX or MIC. adjust
the main volume controlling button, until LED element 3 (+6dB) and LED element 4 (+8dB) shall
flash .You can not record if tape is protected.
4. Using External Signal
Press key AUX for selecting external program from AUX port on rear panel.
5. Using Microphone
Volume down the Microphone Volume to avoid strong vibration when inserts a Microphone.
Insert the Microphone into socket MIC1 or MIC2 with a 6.35mm plug, and turn the relative Volume knob in a moderate
standard to avoid any damage. MIC1 have such a priority that when it is sound all others signal that is playing has to give
way to it. This MUTE function is for emergent speaking. We can also adjust the suppressing level with MUTE LEVEL
on the rear panel.
6. Built-in Chime
Pressing key CHIME and melody ‘ 1 3 5 i ’ is to be played with the priority function same as MIC1. We can also tune
the volume of it by CHIME controller on the rear panel.
6. Remote control
Remote control device can operate it by timer through the cable.
PRECAUTIONS
1 Does not block ventilation holes.
2 The set should not be placed areas:
1) with poor ventilation.
2) exposed to direct sunlight.
3) with high ambient temperature or adjacent to heat generating equipment.
4) with high humidity or dust levels.
5) susceptible to vibration.
3 Make sure the power outlet conforms to the plug of the unit.
4 Do not use this unit if the electrical power cord is frayed or broken.
5 Always operate the unit with the AC ground wire connected to the electrical system ground
6
SPECIFICATIONS
CD Section
Frequency response 20 Hz-20 kHz
Signal to Noise Ratio
98dB
Dynamic range 90 dB
THD 0.005%
Wow & Flutter Under the limited level
Tuner Section
AM
Sensitivity 50 dBμ
Wave Band 525 ~ 1625 kHz
Band width 6 kHz
Signal to Noise Ratio
50 dB
FM
Sensitivity 2 μV
Wave Band 87.5 ~ 108.0 MHz
Band width 15 kHz
Signal to Noise Ratio
75 dB
Cassette Section
Tape Speed 4.76 cm/sec
Wow & Flutter Less Than 0.1%
Frequency response 125 Hz ~ 6.3 kHz
Signal to Noise Ratio
50 dB
7
Amplifier Section
Model PM8006 PM8012 PM8025 PM8035
Output 60W 120W 250W 350W
Output Regulation Less than 5 %
Speaker Output Balanced 4Ω, 70V, 100V
AUX Out 600Ω, 1V ( 0 dBV )
Input MIC 1,2: 600Ω, 2.5 mV ( -52dBV ), unbalanced
AUX: 10 kΩ, 150 mV ( -17 dBV ), unbalanced
Frequency Response
MIC 100 Hz ~10 kHz; AUX 100 Hz ~ 16 kHz
Distortion Less than 0.5% at 1 kHz , 1/3 rated power
Signal to Noise Ratio
MIC 1,2: 66 dB
AUX: 70 dB
Tone Bass: ±10 dB at 100 Hz
Treble: ±10 dB at 10 kHz
Protection AC fuse, DC voltage, overload and short circuit
Muting Function MIC 1 overrides other input signals with 0 ~ -30 dB attenuation
Power Requirements
AC 220 ~240 V / 50 ~ 60 Hz
Power Consumption
120W 250W 500W 650W
Dimensions (mm) 420×400×132
Specifications are subject to change without notice
Caution
To reduce the risk of electric shock, do not remove the cover.
No user parts inside. Refer servicing to qualified service personnel.
LY INTERNATION ELECTRONICS CO., LTD
HTTP://WWW.LYINTLCORP.COM/
/
