XL Flooring drop & done NORDIC, drop & done BALI MERBAU Installation guide

  • Hello! I am an AI chatbot trained to assist you with the XL Flooring drop & done NORDIC Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
DROP & DONE INSTALLATION INSTRUCTIONS
OPTIONS
1. Drop&Done can be installed loose-lay with two-sided tape around the perimeter of the room.
2. Drop&Done can be installed full spread with release adhesives such as Mapei Eco 810.
3. For heavy duty commercial applications, Drop&Done can be glued down permanently with Mapei Eco
360 or Henry’s 422.
4. For installation over radiant heat, we recommend to use the permanent glue method.
SUBFLOOR
Drop & Done can be installed over any hard and flat surface. You do not have to double your plywood. You do
not have to remove existing vinyl. Over ceramic tiles, you need to fill the grout lines with a proper leveling
compound. Subfloor must be even within 1/8" over 6'.
Caution; Drop & Done is not suitable for installation over carpet.
PREPARATION
The material should be allowed to acclimatize at room temperature (approx 20 ˚C) for 48 hours prior to
installation. New concrete floors need to dry out for at least 60 days prior to installation. Make sure the floor is
smooth, clean, and free of wax, grease, oil or dust. Uneven areas must be fixed with a proper leveling
compound.
INSTALLATION:
Install two-sided tape (6 to 8 cm wide) or apply a 10 cm wide strip of release adhesive around the perimeter of
the room. If you use glue, let the adhesive dry for 20 minutes or until it can be touched without transfer.
For full spread installation with release or permanent adhesive, follow instructions on the pales, Begin laying
your floor SNUG along the longest wall. Lay a complete row of planks and cut the last one to fit against the
opposite wall. The cut edge should always face the wall. When you reach the last row, cut the last plank to fit
SNUG. The plank should not be forced into place. For best visual effect, always stagger the planks from row to
row.
MAINTENANCE
Easy as 1-2-3-
Sweep, Vacuum and Mop floor regularly!
Our strong polyurethane coating will protect your floor for many years. Follow the precautions below for
keeping your floor looking good for years to come.
Use plastic, glass or other non-staining cups with flat under surfaces not less than 2 inches in diameter for legs
of heavy appliances and furniture. Use proper floor protectors on all chairs. Remove all small diameter buttons
from legs of straight chairs and replace with medal glides no smaller than 1inch in diameter. Examine your
protectors periodically, check for burs or debris or wear make sure the surface is smooth. Do not drag any
types of furniture across your floor! Avoid rolling type caster chairs if possible. If not make sure the rollers are
the double type wheels at least 2” in diameter. These precautions will prevent scratches and indentations from
appearing on your floor.
Do not expose floor to frequent standing water and wipe up all spills quickly. Watch for tracked in dirt and grit
particles. Use walk off mats at all room entrances. Do not use rubber or latex back mats. Certain chemicals in
backing can stain vinyl. Use Non-staining vinyl mats or woven rugs that are colorfast.Avoid exposure to direct
sunlight for prolong periods. The use of drapes and blinds are recommended. Direct sunlight over long period
of time can cause discoloration.
No finishes are needed. SOFT CERAMIK has a strong permanent polyurethane finish. Do not use any type of
harsh detergent or solvents like lacquer thinner, abrasive cleaners or Mop and Shine type products, which can
leave a film. Avoid vinegar as a cleaning agent. Use cleaners that are recommended for vinyl. The use of
steam mops is ok. Do not use vacuums with beater bars.
Commercial Maintenance:
Follow same recommendations as above. Daily sweeping, dust mopping or vacuuming will prevent dirt and grit
particles from being grounded into surface of plank or tile. The amount of foot traffic will dictate you
maintenance program but washing the floor by damp mopping and use of an auto scrubber should be part of
the program. Heavy use and extremely dirty floors should be scrubbed with a175-300RPM-floor buffer. No
Scrubber or Buffer can exceed 300 RPM! A red type pad should be used for scrubbing and a white pad for
buffing. Suitable made for vinyl-cleaning products should be used.
LIFETIME RESIDENTIAL WARRANTY
Our Lifetime Residential Limited Warranty for Drop & Done means that for as long as you own your house,
from the date of purchase, your floor will be free from manufacturing defects and will not wear through or
permanently stain from common household products when installed and maintained according to instructions
supplied with each carton. This guarantee applies only to the original purchaser and proof of purchase is
required for all claims. The guarantee is for replacement or refund of the vinyl planks only, no labor. Claims for
wear must show a minimum dime size area. High-heeled shoes, rolling carts, furniture and chairs without
protective pads can damage the floor and are not covered by this warranty. If you wish to file a claim under
warranty, contact the authorized dealer where the flooring was purchased.
15-YEAR COMMERCIAL WARRANTY
Our 15 Year Limited Commercial Warranty for Drop & Done means that for fifteen years, from the date of
purchase, your floor will be free from manufacturing defects and will not wear through when installed and
maintained according to instructions supplied with each carton. This guarantee applies only to the original end
user and proof of purchase is required for all claims. The guarantee is for replacement or refund of the material
only, no labor. Claims for wear must show a minimum dime size area. High-heeled shoes, rolling carts,
furniture and chairs without protective pads can damage the floor and are not covered by this warranty.
.
/