2. Computers & electronics
  3. Networking
  4. Network antennas
  5. Datalogic
  6. Magellan 2200VS
Magellan 2200VS

Datalogic Magellan 2200VS, Magellan 2300HS Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Datalogic Magellan 2200VS Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installation Instructions
Magellan
®
2200VS/2300HS EAS Kit
Remove the scanner from its mounted position and disconnect all cables.
1
Place the scanner face down on an ESD protected surface and detach the...
...Front Enclosure ...Top Enclosure
2
Turn the scanner face up, lift off the Front/Top Enclosure, then remove the Chassis.
3
This kit is available only to qualified modular level service providers. Reference the service
manual for your product to find requirements for ElectroStatic Discharge (ESD) protection and
full details regarding the removal and replacement of parts and assemblies.
These instructions explain how to install the EAS wire in either of two scanner models.
Instructions specific to Magellan 2200VS scanners are shown below on the left side of the page
and Magellan 2300HS scanner instructions are shown on the right.
Lift the scanner straight up and
out of its mount.
Lift off the Top Cover, then
use the Lift Handles to remove
the scanner from the counter.
R44-2717 (Rev. A)
4
Seat the EAS Wire inside the enclosure in the guides as shown. It may be helpful to use a
toothpick or similar tool to push the wire fully into position within the guides.
6
7
Power
EAS Opening
Aux. Port
Scanner Host
Power
Aux. Port
Scanner Host
Peel off the EAS portion of the
connector label from the Lower/Back
Enclosure to expose the opening for
the wire.
5
Feed the loop end of the EAS Wire
through the EAS opening, then seat
the rubber grommet in the hole.
(Both models) (Both models)
Guides
EAS Wire
Guides
Guides
EAS Opening
Scanner Host
Reassemble and remount the scanner as described in the service manual, taking care to
ensure the EAS wire remains seated in the guides. Use the other kit contents (EAS Antenna
label and cable tie) at your own discretion to optimize the installation. This completes
these instructions.
To EAS
System
/