LC2000r - NetServer - 128 MB RAM

HP LC2000r - NetServer - 128 MB RAM, D5970A - NetServer - LCII, D7171A - NetServer - LPr, LH4r - NetServer - 256 MB RAM, LH6000r - NetServer - 0 MB RAM Reference

  • Hello! I am an AI chatbot trained to assist you with the HP LC2000r - NetServer - 128 MB RAM Reference. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What is the default switch settings for SCSI, IDE CD-ROM, and flexible disk?
    How to clear the configuration memory (CMOS)?
    How to remove the terminator for CPU #2?
    What is the maximum CPU frequency supported?
    How to set the system board configuration?
Standard Model
1.
2.
3.
4.
5.
6.
7.
8.
9.
Boot Order
IDE CD-ROM
Floppy Drive
Embedded SCSI
PCI 6
PCI 5
PCI 4
PCI 3
PCI 2
PCI 1
System Board
12
CPU Frequency (by MHz)
D4906-80201, Rev C
See your Hewlett-Packard Resellers for the following accessories:
Selected HP Accessories
P/N: D4906-80201, Rev C
This information is subject to change without notice and is
provided without warranty.
For other tested accessories, download the Order Assistant
from the HP Web page.
Password (6)
Clear Password
Config. Memory (5)
Clear Config. (CMOS)
4.2GB Ultra SCSI Hot-Swap Disk Module (7200 RPM)• D3583C
9.1GB Ultra SCSI Hot-Swap Disk Module (7200 RPM)• D4289A
Remove Terminator
for CPU #2
DIMM Installation
NetServer LC II Service / Accessory
Information
Even at low room temperatures, all covers and panels must
be in place to provide controlled airflow for system reliability.
Audience Assumptions
This Service Reference Label is for trained service personnel.
Hewlett-Packard Company assumes you are qualified in the
servicing of computer equipment and trained in recognizing
hazards in products with hazardous energy levels.
Electrostatic Discharge To avoid catastrophic or hidden
damage to components, wear a wrist strap and use a static-
dissipative work surface connected to the chassis when
handling components. Use an antistatic service kit, such as
3M 8501/8502/8505 or equivalent.
®
© 1997, Hewlett-Packard Company.
All rights reserved.
• Internet Web Page http://www.hp.com/go/netserver
• Internet FTP ftp://ftp.netserver.hp.com
• CompuServe Library GO HPPC
• HP NetServer BBS 1-208-344-1691
• HP Navigator CD
Electronic Support Services
HP has offices in over 100 countries. Check your local
telephone directory.
Support Questions:
• HP-Authorized Reseller
• CompuServe Discussion Forum GO HPPC
• US / Canada Phone Support 1-970-635-1000
• Europe Phone Support (+31-20) 581-3330 (Netherlands)
=Compressed
Optional HP 3 Year On-Site Support Pack
3 Year, On-site, Same Day• H5519A
On-site Installation and Network Configuration• H5751A
3 Year, On-site, 7 day / 24 hour• H5514A
Network Interface Card
HP NetServer LAN Adapter• D5013A
Memory
32MB DIMM• D4295A
64MB DIMM• D4296A
128MB DIMM• D4297A
HP SureStore 5000i 4GB Internal Tape Drive C1526H
HP SureStore 24i Internal Tape Drive C1555B
Backup
HP SureStore DAT8i Internal Tape Drive D1528H
HP SureStore T4i 8GB Internal Tape Drive C5644A
Mass Storage
24X Max IDE CD-ROM• D4383A
4.2GB 10K Ultra SCSI Hot-Swap Disk Module
(10000 RPM)
• D4903A
9.1GB Ultra/Wide SCSI HDD (7200 RPM)• D4911A
4.2GB Ultra/Wide SCSI HDD (7200 RPM)• D4910A
Test (8 & 7)
CPU
Speed
Hot-Swap Model
Flexible Disk
Flexible Disk
CD-ROM
Shelf 2
Shelf 3
Shelf 4
Backplane
Shelf 1
Shelf 5
Shelf 6
SCSI
IDE CD-ROM
**
C42
D6
FC
Shipped with the
ARRAY Model only
*
NetRAID 1
Backplane
PCI 5: NetRAID 1
(Array Model)
PCI 4
PCI 3
PCI 2
PCI 1 / ISA
To Management
Port
*
To Control Panel
Flexible Disk
IDE CD-ROM
SCSI
*
Requires External Modem
for Remote Access
SCSI
A I C
7880
PCI 6: LAN Adapter
Remote
Access
To System Board
ON
OFF
266
ON
OFF
300
ON
OFF
233
ON
OFF
333
Flexible
Disk
Shelf 3
CD-ROM
Control
Panel
Backplane
Power Supply
Management
Port
Fan Cable
System Board
Backplane
Power Supply
Management
Port
Fan Cable
Shelf 4
Shelf 3
CD-ROM
Flexible
Disk
Shelf 5
Shelf 6
Control Panel
System Board
**
Flexible
Disk
Flexible Disk
CD-ROM
Shelf 2
Shelf 3
Backplane
Shelf 1
SCSI
IDE
CD-ROM
103
OUT IN
Rear View
sw
End of
Cable C52
1
2
3
4
5
6
OFF ON
Default Switch
Settings (1, 0, 3)
SCSI ID 2
reserved for DAT
1
2
3
4
5
6
OFF ON
If Shelf 3 has
SCSI ID set to 0
Alternate Switch
Settings (1, 2, 3)
Cabling Key
Built-in SCSI Terminator
I C
2
C82
I C Cable (5182-6730)
2
I C
2
68-pin to 50-pin Adapter (for
tape backup only) (5183-2427)
**
Available Connector
Engaged Connector
68-pin SCSI Cable (5183-2412)
C42
IDE CD-ROM Cable (5183-2411)
Flexible Disk Cable (5183-2410)
68-pin SCSI Cable (5183-2484)
68-pin SCSI Cable (5183-3488)
*
Monitor
0123
Serial B
Serial A
Parallel
Mouse
Keyboard
Battery
System Switch
1MB VRAM
1MB VRAM Upgrade
(D4219A)
Video Controller
Voltage Regulator
Module #1
CPU #2
CPU #1
Voltage Regulator
Module #2
Terminator
I/O
DIMMs
*
D6
FC
C52
D6
FC
C52
*
Array Model
C82
C52
C52
/