Hercules 422562 Installation guide

Type
Installation guide
TOILET FLANGE
INSTRUCTION GUIDE
2
3
4
6
5
7
1
Cut the pipe to the desired height.
Dry t ange into the pipe to check for interference.
Apply approved Oatey primer using approved application
methods to the ange and the drainpipe.
Apply approved Oatey cement using approved application methods to the ange and drainpipe.
Secure the ange in place using approved screws and possibly anchors for your application.
Screws should pass through the nished oor and be secured into the suboor.
Push the ange down onto the pipe until it is setting ush with or on top of the nished oor.
Find the center of the ange and install the Johni-bolts.
©2020 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com
  • Page 1 1

Hercules 422562 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI