Triumph Adler LP 218 Operating instructions

UTAX LP 118

Laser Printer 300 Series

your office partner

INSTRUCTION HANDBOOK

please read the instruction handbook

carefully before using this machine. keep it

close to the machine for easy reference.

i

Foreword

Safety Information

Laser Safety

This is a page printer which operates by means of a laser. There is no

possibility of danger from the laser, provided the printer is operated

according to the instructions in this manual.

Since radiation emitted by the laser is completely confined within pro-

tective housing, the laser beam cannot escape from the machine during

any phase of user operation.

Internal Laser Radiation

Maximum Radiation Power:

1.03 mW at laser aperture of the print head unit

Wavelength:

770–810 nm

This product employs Class IIIb Laser Diode that emits an invisible

laser beam.

Laser Diode and Scanning Polygon Mirror are incorporated in the print

head unit.

The print head unit is not a field service item.

Therefore, the print head unit should not be opened under any circum-

stance.

Laser Safety

This printer is certified as a Class I Laser product under the U.S.

Department of Health and Human Services (DHHS) Radiation Per-

formance Standard according to the Radiation Control for Health and

Safety Act of 1968. This means that the printer does not produce haz-

ardous laser radiation.

ii

Foreword

CDRH Regulations

The Center for Devices and Radiological Health (CDRH) of the

U.S. Food and Drug Administration implemented regulations for laser

products on August 2, 1976. Compliance is mandatory for products

marketed in the United States. The label shown below indicates com-

pliance with the CDRH regulations and must be attached to laser prod-

ucts marketed in the United States.

Laser Safety Label

Caution

◆ Use of controls, adjustments or performance of procedures other

than those specified in this manual may result in hazardous radia-

tion exposure.

iii

Foreword

Caution

Laser Caution Label

◆ This is a semiconductor laser. The maximum power of the laser

diode is 5 mW and the wavelength is 770–810 nm.

iv

Foreword

User Instructions

FCC Part 15 - Radio Frequency Devices Warning (for

U.S.A. Users)

FCC: Declaration of Conformity

Product Type Laser Beam Printer

Product

Name

Laser Printer 300 Series

Options Second Paper Cassette Unit

Third Paper Cassette Unit

Duplex Unit

Expansion memory (Maximum 96MB)

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following conditions;

1. this device may not cause harmful interference, and

2. this device must accept any interference received, including

interference that may cause undesired operation.

v

Foreword

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interfer-

ence to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interface by one or more of the follow-

ing measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the

receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

This device must be used with a shielded interface cable and shielded

network cable. The use of non-shield cables is likely to result in inter-

ference with radio communications and is prohibited under FCC rules.

The design and production of this unit conform to FCC regulations,

and any changes or modifications must be registered with the FCC and

are subject to FCC control. Any changes made by the purchaser or user

without first contacting the manufacturer will be subject to penalty

under FCC regulations.

vi

Foreword

Warning

Interference-Causing Equipment Standard (ICES-003

ISSUE 3) Warning (for Canada Users)

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-

003 du Canada.

This Class A digital apparatus (4179-261) complies with Canadian

ICES-003.

Cet appareil numérique de la classe A (4179-261) est conforme à la

norme NMB-003 du Canada.

Ozone Release

During printer operation, a small quantity of ozone is released. This

amount is not large enough to harm anyone adversely. However, be

sure the room where the machine is being used has adequate ventila-

tion, especially if you are printing a high volume of materials, or if the

machine is being used continuously over a long period.

◆ The design and production of this unit conform to FCC regulations,

and any changes or modifications must be registered with the FCC

and are subject to FCC control.

◆ Any changes made by the purchaser or user without first contacting

the manufacturer will be subject to penalty under FCC regulations.

vii

Foreword

Welcome

And thank you for selecting a Laser Printer 300 Series Printer!

This User’s Manual explains the functions of the printer and how it

operates. It also provides you with troubleshooting tips as well as gen-

eral precautions you should observe when operating the printer. To

ensure the top performance and effective use of your printer, read this

manual carefully from cover to cover, and keep it at hand for later ref-

erence.

The contents of this manual are subject to change without notice.

Should there be any discrepancy between the printed materials and the

electronic-based resources provided with your printer, please refer to

the printed materials as your primary resource.

Trademark Acknowledgments

PCL is a registered trademark of Hewlett-Packard Company.

Centronics is a registered trademark of Centronics Inc.

Microsoft, Windows, and Windows NT are registered trademarks of

Microsoft Corporation.

All other brand or product names are trademarks or registered trade-

marks of their respective companies or organizations.

viii

Foreword

viii

Contents

Laser Safety......................................................i

Ozone Release...............................................vi

Trademark Acknowledgments........................vii

Introduction..........................................................1--1

Operating System ........................................1-1

Indicators...................................................... 1-5

Panel Button.................................................1-6

Setting-Up.............................................................2--1

Selecting a Location for the Printer..............2-1

Operating Environment................................2-5

Printer...........................................................2-5

Printer Supplies............................................ 2-7

Unpacking the Printer...................................2-8

Installing the Face-Down Tray....................2-10

Installing Tray 1.......................................... 2-11

Connecting the Power Cord.......................2-12

Second/Third Paper Cassette Unit.............2-20

Expansion Memory ....................................2-30

Using the Printer..................................................3--1

Print Configuration Page..............................3-1

Form Feed.................................................... 3-1

Type .............................................................3-2

Paper Type.................................................3-18

Paper Size..................................................3-18

ix

Contents

PCL Printer Driver................................................4--1

Introduction...................................................... 4-1

System Requirements..................................... 4-2

Installing the USB Device Driver for the Laser

Printer 300 Series............................................ 4-3

To Install the USB Device Driver Under Windows

98.................................................................4-3

To Install the USB Device Driver Under Windows

Me................................................................4-6

To Install the USB Device Driver Under Windows

2000.............................................................4-9

Installing the PCL Printer Driver Under Windows

95.....................................................................4-17

To Install the PCL Printer Driver Using Plug-and-

Play............................................................4-17

To Install the PCL Printer Driver Using the Add

Printer Wizard ............................................4-19

Installing the PCL Printer Driver Under Windows

98/Windows Me..............................................4-21

To Install the PCL Printer Driver Using Plug-and-

Play Under Windows 98.............................4-21

To Install the PCL Printer Driver Using Plug-and-

Play Under Windows Me............................4-23

To Install the PCL Printer Driver Using the Add

Printer Wizard ............................................4-25

Installing the PCL Printer Driver Under Windows

NT 4.0.............................................................. 4-27

x

Contents

To Install the PCL Printer Driver Using the Add

Printer Wizard ............................................4-27

Installing the PCL Printer Driver Under Windows

2000.................................................................4-30

To Install the PCL Printer Driver Using Plug-and-

Play............................................................4-30

To Install the PCL Printer Driver Using the Add

Printer Wizard ............................................4-33

Installing the Laser Printer 300 Series Utilities4-

36

Using the PCL Printer Driver........................ 4-38

Displaying the PCL Printer Driver Setup Dialog

4-38

Common Buttons .......................................4-42

Setup..........................................................4-43

Paper..........................................................4-51

Quality........................................................4-55

Device Options Setting...............................4-58

Using the Status Display............................... 4-59

Starting Up the Status Display.................... 4-59

Using the Status Display............................4-61

Using the Control Panel................................4-63

Starting Up the Control Panel.....................4-63

Using the Control Panel.............................4-65

Uninstalling the PCL Printer Driver ............. 4-72

xi

Contents

To Uninstall the PCL Printer Driver ............4-72

Uninstalling the Laser Printer 300 Series Utilities

4-76

To Uninstall the Laser Printer 300 Series Utilities

4-76

Uninstalling the USB Device Driver.............4-80

To Uninstall the USB Device Driver............ 4-80

Maintenance.........................................................5--1

To Replace the Imaging Cartridge................ 5-2

Cleaning the Outside of the Printer..............5-8

Cleaning the Paper Feed Roller...................5-9

Troubleshooting...................................................6--1

Clearing a Paper Misfeed................................6-1

Inside the Printer.......................................... 6-1

Face-Down Tray...........................................6-6

Tray 1...........................................................6-6

Manual Feed Tray........................................6-8

Second/Third Paper Cassette Unit (Option).6-9

Duplex Unit (Option)................................... 6-10

Print Quality Problems.................................. 6-12

No Output................................................... 6-17

USB Connection Problems...........................6-19

Is the computer equipped with a system that

enables USB connections?........................ 6-19

xii

Contents

Was the computer correctly set up?........... 6-20

Indicator Lights (Printer Messages) ............6-30

Indicator Light Patterns..............................6-30

Specifications.......................................................7--1

Parallel Interface.......................................... 7-7

xiii

Contents

MEMO

xv

Contents

Chapter 1Introduction

1

1Chapter

Introduction

Chapter 1Introduction

1-1

Chapter 1Introduction

Features

The various features listed below make the Laser Printer 300 Series the

powerful printer for any size office.

• Fast 18-page-per-minute print speed for quick output

• 1200 × 600 dpi resolution for superior print quality

• PCL 6 emulation for powerful printer language support

• 66 MHz RISC processor for high-performance printing

• 8 MB of memory (standard)

• USB interface built in

Operating System

• Windows 95

• Windows 98

• Windows Me

• Windows NT 4.0

• Windows 2000

Page is loading ...

Triumph Adler LP 218, LP 118 Operating instructions

Other documents