Annin Flagmakers 242 Operating instructions

Type
Operating instructions
COPYRIGHT 2013 • ANNIN FLAGMAKERS, ROSELAND, NJ 07068
Remove set screw from one fastener and slide fastener up from bottom
of pole to just below the ornament. The spinning snap hook should be
hanging down towards the bottom of the pole when the pole is held
upright.
Stop Your Flag from Tangling!
Instructions:
No Tools Required!
Fasteners slip over pole and hand-tighten; swivel clips fit any flag with grommets.
Adjust the fasteners so that there is no slack in the heading of the flag
but do not make the heading too taut or else the flag will not spin.
Clip the snap hook to the lower grommet of your flag.
Replace the set screw and hand-tighten.
Remove set screw from the second fastener and slide fastener up from
bottom of pole to a point where it is parallel to the lower grommet of your
flag. This second fastener should be slid onto the pole the opposite way
from the first fastener so that the spinning snap hook is on the inside
facing the first spinning snap hook.
Clip the snap hook to the top grommet of your flag.
Replace the set screw and hand-tighten.
ASSEMBLY INSTRUCTIONS FOR SPINNING FASTENERS
  • Page 1 1

Annin Flagmakers 242 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI