Rest Rite RRTCMB01853TW Installation guide

Type
Installation guide
STEP 8
SETUP INSTRUCTIONS
ASSEMBLY INSTRUCTIONS (CONTINUED)
STEP 5 STEP 6
First install the Short Rail (Part A) to the platform
frame using 1/2” Bolts (Part K), after that install
Long Rails (Part B) using 1/2” Bolts (Part K). Secure
the bolts tightly.
Use 5/8” Bolts (Part J) to attach the end legs.
Secure the bolts tightly.
14
SIZE: TW
J
K
B
B
A
STEP 7
Install the Support Brackets (Part D) to attach
the rails using 3/8” Bolts (Part I).
Secure the bolts tightly.
Note: There are a total of 4 bolts for the two
support brackets.
I
I
D
Enjoy your new platform bed!
STEP 1
HARDWARE LIST
A. Short Rail
(1 pc)
Platform Bed Setup Instructions
Contains One (1) Bed and Hardware
IMPORTANT NOTE:
Carefully remove all parts from the carton. Arrange on a at
surface to verify all of the following parts and hardware are present.
PART LIST
TOOLS REQUIRED:
Phillips Screwdriver
(Continued on back)
ASSEMBLY INSTRUCTIONS
C. L-Brackets
(2 pcs)
B. Long Rail
(2 pcs)
D. Support
Brackets
(2 pcs)
G. Brackets
(2 pcs)
H. Platform Frame
(1 pc)
I. 3/8” Bolt (6 pcs) J. 5/8” Bolt (2 pcs) K. 1/2” Bolt (10 pcs) L. Hex Key (1 pc)
E. Short Side Board
(1 pc)
F. Long Side Board
(2 pcs)
STEP 2
STEP 3 STEP 4
Install the L-Brackets (Part C) onto both Long Side Boards (Part F)
using the 3/8 Bolts (Part I). Secure the bolts tightly.
Insert the Short Side Board (Part E)
into the Brackets (Part G).
Insert the Long Side Boards (Part F) into the
Brackets (Part G).
32
SIZES: TW
I
C
F
I
C
G
G
E
E
F
F
G
G
Unfold the bed and lay at upside down. Raise all six legs to upright position.
Each of the four end legs have separate support arms. Rotate support arms to hook
on to the bolts and tighten with preinstalled wing nuts. Turn the bed upright.
Note: Two center legs do not require support arms and wing nuts.
  • Page 1 1
  • Page 2 2

Rest Rite RRTCMB01853TW Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI