Note: All Statements, technical information, and recommendations contained herein are based on information the company believes to be reliable.
The accuracy or completeness thereof is not guaranteed. In accordance with “Terms and Conditions,” and since conditions of use are outside of
the company’s control, the purchaser should determine the suitability of the product for its intended use and assumes all risk and liability
whatsoever in connection herewith.
RISK OF ELECTRICAL SHOCK. TURN MAIN SWITCH AND CIRCUIT BREAKER TO “OFF” POSITION
BEFORE SERVICE OR RELAMPING.
All electrical connections must be in accordance with local codes, ordinances and National Electrical Code.
If you are unfamiliar with proper electrical wiring or connections, secure the services of a qualified licensed
electrician.
Proper grounding of the fixture is essential for protection from shock, correct operation of the electronic
driver and the elimination of electrical interference.
ITEMS PROVIDED
INSTALLATION INSTRUCTIONS
Undercabinet LED Luminaire
08/2019
IMPORTANT: Read carefully before installation and retain for future reference.
Input: 120V
WIRING DIAGRAM
Figure 1A
Lens and Cover Disassembly
Figure 2A
Cable Connector LED Under Cabinet Mounng Screws Wire Nuts
1. Remove Lens by applying pressure to the front of the lens and liing upwards. (Refer to Figure 1A)
2. Remove Cover by applying pressure to the front part of the cover and li cover upwards to clear the tabs on housing. (Refer to
Figure 2A)
1. Remove desired knockout hole by hammering it out with a screw driver and hammer. (Refer to Figure 3A)
2. Install Cable Connector to housing by feeding thru knockout hole and ghtening the nut provided. (Refer to Figure 4A)
3. Secure housing to the boom of the cabinet with mounng screws provided. (Refer to Figure 5A)
4. Feed Input supply wires thru cable connector and ghten cable connector. (Refer to gure 6A)
5. Connect input supply wires to wires on xture Green to Green (Ground ), White to White (Neutral), and Black to Black (Live)
(Refer to Figure7A)
6. Reinstall the Lens and Cover by reversing steps in lens and cover disassembly. (Refer to Figure 1A and 1B)
Installation
Figure 3A
Figure 4A
Figure 5A
Figure 6A
Figure 7A
These instrucons do not claim to cover all details or variaons in the equipment, procedure, or process described, nor to provide direcons for meeng every possible conngency during installaon, operaon or
maintenance. When addional informaon is desired to sasfy a problem not covered suciently for user’s purpose, please contact your nearest representave.
/
