Combi 9835 User manual

Brand: Combi

Model: 9835

Type: User manual

Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE

REFERENCE. Record the following information for quick reference.

Note: Illustrations are only representative and not actual.

Attach copy of sales receipt.

Parts List

Name of Parts

Make sure you have all the parts listed below before using your high chair. If any parts are miss-

ing, call Consumer Affairs at 1-800-992-6624.

1 Seat Cushion

2 Shoulder Harness

3 Snack Tray

4 Chair

5 Footrest

6 Table / High Chairbase

Fabric Pattern ____________________________________________________

Located underneath the seat.

Combi USA, Inc. • 1962 HWY 160 W, Suite 100 • Fort Mill, SC 29708 • www.combi-intl.com

Consumer Affairs 1-800-992-6624

Date Purchased: _______________________________ Model Number: ________ - _______ Color ___________________________________________________

7 Chair 8 Table 9 Book Stand

Transition

Instruction Manual

Beam

Footrest

Nuts

(x14)

Seat

Table Legs

(x2)

Chair Legs

(x2)

Table Top

SnackTray

- 2 -

WARNINGS:

CHOKING HAZARD: This product contains small parts that can pose a possible choking hazard.

ALL OPERATING AND ASSEMBLY PROCEDURES SHOULD BE PERFORMED BY AN ADULT.

In the event of damage or problems, discontinue use and contact Consumer Affairs

for instructions: 1-800-992-6624.

Do not use with more than

one child.

All products specifications are subject to change without notice. Sizes and weights are intended as guides and are approximations.

Combi® reserves the right to modify the products in its line during the course of the year. Non contractual media. Colors are as accurate as the media in which they appear allows.

©Combi USA, Inc. 2004

FAILURE TO FOLLOW THESE INSTRUCTIONS AND

WARNINGS COULD RESULT IN SERIOUS INJURY OR DEATH.

Be sure that all parts are

securely locked into place

before use.

NEVER LEAVE CHILD

UNATTENDED.

Prevent serious injury or

death from falls or sliding out.

Discontinue use immediately

if any part is found to be

damaged or broken.

Your high chair is intended

for domestic use only, it is not

intended for commercial use.

Never lift or carry your

high chair while occupied.

Once the high chair is

mounted, make sure that

all the screws are securely

fastened and check them

periodically.

Total Maximum weight of

the child MUST not exceed 40

lbs. (18 kg).

Be careful to keep your

high chair away from hazards

such as heaters, stoves, etc.

Make sure that the safety

belts are correctly adjusted to

the baby's size.

Adjust the 5-point

harness according to the size

of your child. Adjust for every

reclining position.

Completely remove all

plastic bags and packing

materials before using this

product to prevent a possible

choking hazard.

The child should be

secured in the high chair at

all times by the restraining

system, either in the reclining

or upright position. The

tray is not designed to hold

the child in the chair. It is

recommended that the high

chair be used in the upright

position only by children

capable of sitting upright

unassisted.

Always keep child in view

while in high chair.

This high chair is

designed for use by children

up to 3 years of age.

Always secure child in the

restraint.

WARNING: All parts must be used to assemble the high chair. Removing parts from assembly

will affect the stability of the high chair and may cause injury or breakage.

- 3 -

Assembly of Table

Final assembly of the table.

1. Attach the beam to one

leg of the table.

2. Insert plastic nut and tighten

using a coin.

3. Attach the table top to

the side leg and beam and

tighten the nuts.

4. Attach the remaining table

leg to the side of the table

and tighten the nuts.

- 4 -

Assembly of Chair

2. Attach the footrest to the seat

leg as shown and tighten nuts.

3. Attach the other seat leg to the

seat base as shown and tighten

the nuts.

Final assembly of the chair.

1. Attach the seat and backrest

to the seat leg as shown and

tighten nuts.

Make sure the metal rod in the backrest

aligns properly with the guides in the

seat leg before tightening the nuts.

WARNING

Possible pinching hazard, keep fingers clear

of hinges on seat during assembly.

- 5 -

Attaching / Removing Seat Cushion

1. Place seat cushion onto the seat and

push shoulder harnesses and waist

belts through the openings in the

seat cushion.

2. Slide the seat cushion

snugly over the backrest as

shown.

3. Pass the crotch strap through the

opening of the seat cushion as

shown.

4. Snap together the buttons of the

seat cushion to the underside of the

chair.

Final assembly of the chair.

Removing the Seat Cushion:

To remove the seat cushion, reverse the

instructions shown in steps 1 though 4

above.

- 6 -

Attaching the Seat to the Table

1. Turn the table on one side with the beam

on top. Place the chair on top and set into

the beam hole until it locks with a clicking

sound.

Attaching, Adjusting and Removing the Snack Tray

Attaching:

1. Align the snack tray to the grooves of the armrest.

2. Slide the snack tray onto the chair while pressing in

the release buttons on each side underneath the tray.

Adjusting:

1. While pressing in the release buttons, slide the snack

tray to one of the three slots and release the buttons.

Make sure the buttons snap back out to ensure it is

locked in place. Gently pull on the tray to ensure that

it is locked into the desired position.

Removing:

1. Press in the release buttons underneath the snack tray

and remove tray from the seat.

Adjusting the Recline of the High Chair

1. Pull up on the release lever on the back of the chair and

change the position of the backrest as shown. Ensure that

the backrest is locked in position by gently pulling on the

backrest.

Removing the High Chair From Base

1. Push the button on the underside of the

seat and push the chair upwards as shown.

- 7 -

Routine Maintenance

STORE IN A DRY AREA to ensure that mold and corrosion do not occur. High chair should be

thoroughly dried before storing.

PLASTIC PARTS OF CHAIR AND TABLE

Hand wash with a sponge and warm soapy water.

SEAT CUSHION

Machine Wash Cold; Gentle Cycle and Line Dry.

Excessive exposure to the sun could cause premature color fading of plastic and

fabric.

Charge to my credit card:

 VISA  MASTERCARD

 AMERICAN EXPRESS  DISCOVER

Card Number

Expiration Date __________ - ___________ - ____________

Cardholder’s Signature

Parts Order Form

If you would like to place an order for the replacement parts, please fill out the form below and

return to the following address:

Combi or Fax this completed form to

Attn: Consumer Affairs Department

1962 Highway 160 W, Suite 100

Fort Mill, SC 29708-8027

IMPORTANT: We must have this information to process your order:

Model Number: ________ - ______ Color & Pattern of Fabric: _____________________________________________________

Parts List for the Transition.

Price Quantity Total

1. Seat Cushion

2. Snack Tray

Amount of Order

ADD

Shipping & Handling

Sales Tax (6%)

(SC residents only)

Total

If you need to order other parts for your stroller, please call us toll-free at

1-800-992-6624.

Shipping and Handling Fees: Add $8.00 for orders $34.99 and under. Add

$13.00 for orders $35.00 and over. Note: Additional shipping charges will apply

outside of the Continental U.S.

Combi USA reserves the right to change pricing at any time.

Ship To:

Customer Name

Street Address

City, State, Zip

Telephone Number

032107 REV3

803-548-3663

Located underneath the seat.

Combi USA, Inc. • 1962 HWY 160 W, Suite 100 • Fort Mill, SC 29708 • www.combi-intl.com

Consumer Affairs 1-800-992-6624

Transition

Instruction Manual

Combi 9835 User manual

Combi 9835 User manual

Related papers

Other documents