NAME: Jewels STYLE NO. H5088 DATE. 7/26/2016
Pattern repeat: 1 1/2" x 1 1/2"
SIDE SEAMS
Duplicate the above two steps on other piece of carpet.
If satisfied with pattern match and seam fit, apply seam sealer to both cut edges.
CROSS SEAMS
Use a row finder to find and separate a row across the width that falls in the center of a diamond then use a
Seaming Instructions
Using a row finder, find and separate a row of yarn which runs thru the middle of a diamond.
Using a cushion back cutter cut along the separated row of yarn.
Its best to match pattern from center of seam, then adjust it towards each edge.
Use a premium seaming tape to seam edges together, move seaming iron in of pile direction, set thermostat at 3 to 3 1/2 on iron.
Follow seaming with a seam roller rolling it up and down the seam, then use a seam weight no heavier than 10 lbs,
to hold the seam flat while it cools down.
Allow seam to completely cool off before stretching.
seam, use a seam weight to hold seam flat while seam cools down, weighing no heavier than 10 lbs.
Allow seam to completely cool before stretching.
cushion back , cut along the separated row, do this on both pieces of carpet, on piece with pile lay towards seam
hold cutter on a slight angle to undercut the face fibers, other piece cut straight up and down.
Pull both pieces together ,and shift to bring on pattern match if satisfied with match and seam fit, seam seal both
cut edges and allow to dry.
Using a premium seaming tape, seam pieces together, follow seaming with a seam roller, rolling it up and down
Use a row finder to find and separate a row across the width that falls in the center of a diamond then use a
Using a row finder, find and separate a row of yarn which runs thru the middle of a diamond.
Using a cushion back cutter cut along the separated row of yarn.
Its best to match pattern from center of seam, then adjust it towards each edge.
Use a premium seaming tape to seam edges together, move seaming iron in of pile direction, set thermostat at 3 to 3 1/2 on iron.
Follow seaming with a seam roller rolling it up and down the seam, then use a seam weight no heavier than 10 lbs,
to hold the seam flat while it cools down.
Allow seam to completely cool off before stretching.
seam, use a seam weight to hold seam flat while seam cools down, weighing no heavier than 10 lbs.
Allow seam to completely cool before stretching.
cushion back , cut along the separated row, do this on both pieces of carpet, on piece with pile lay towards seam
hold cutter on a slight angle to undercut the face fibers, other piece cut straight up and down.
Pull both pieces together ,and shift to bring on pattern match if satisfied with match and seam fit, seam seal both
cut edges and allow to dry.
Using a premium seaming tape, seam pieces together, follow seaming with a seam roller, rolling it up and down
/