Figure 1
Assembly Instructions:
Wood may scratch easily, Be
careful when assembling. Do not
scratch.
Unpack and lay parts on clean,
padded surface like carpet or
blanket. Clean the unit(A) well and
open the door panel,check if all the
parts inside are present.
Locate the three holes in the back
of the unit(A) where unit will need
to be mounted to the wall with
wood screws(1) and wall anchors
(2). (see figure at left)
Mark w/ pencil locations on the wall
to match the location of the three
holes on the back of unit (A).One of
the top two mounting locations
will need to be directly into a wall
stud. The wood screw(1) that will
be insert directly into the all stud
will NOT require a plastic wall
anchor(2)
Drill two 1/4” diameter holes in the
wall for the two mounting locations
that will NOT be the placed into the
wall stud. Insert the plastic wall
anchors (2) into the two holes
drilled into the wall.
Place unit (A) against wall. Screw
wood screw (1) through the unit
(A) directly into the wall stud at the
marked location. Then screw the
remaining two wood screws (1)
through unit (A) into the two plastic
wall anchors (2).
Put the compartment into the unit
One screw must be attached
directly into a wall stud. Wall
anchor is not needed when
mounting to wall stud
WALL
WALL
(1)
(2)
Assembly Instructions
Figure 3