1. Locate the area sunlit clear without hanging branches or obstacles.
2. Open folding package buckle will unfold folded sheet, solar panels equipment should face the sun
Tip: In order to obtain the maximum output power of solar modules, it is recommended to adjust the solar
modules based on solar trajectory toward.
3.Replace the battery clip is connected to the battery terminals to ensure that the battery clip is not in contact
with
each other. Red battery clip to positive, black negative battery clamp connection, secure the connection.
4.The battery type setting method
5.Press and hold the program button for more than 5 seconds, the battery indicator LED1, LED2, LED3 will
flash accordingly.
6.Press the button again to set up the exact battery type, after the selection, stop button operation 5
seconds, no flashing lights means complete the setting, the specif
ic content of the following table indicates
LED1 LED2 LED3 Battery Type
(
)
○ ○ × Colloidal lead-acid batteries(Gel)
○ ○ ○
ening lead-acid batteries(Flooded
Note: "○" means lights on "×" means lights off
7. The load switch setting method
When the controller is normal power, press the Set button to achieve the output control of the load. Each
press set key once, the load output will be changed accordingly once off status, only the load output is in the
open state, USB eloquence have 5V voltage output.
1
2
Batt
Solar Panel
Fues
Fues
Load
3
www.ACOPower.com
Power Your Green Life!
105W Foldable solar panel
Instructions