American Standard TONIC 3/6 Lpf Installation guide

American Standard

Brand: American Standard

Model: TONIC 3/6 Lpf

Type: Installation guide

This manual is also suitable for

TF-3104

Bring the toilet as the mark defined, and then mark the holes' position at the back of the toilet

(as the figures shown in the pictures below)

Use the 10mm. drillbit

for bore the holse through the floor.

Cutting of the waste connector as the figures shown in the pictures below.

(In case lenght of trap way is 305 mm.)

(In case lenght of trap way is not 305 mm.)

Connect the waste connector into the toilet

Installing the toilet with the floor

Install the water supply hose Attaching the tank

Water Level Adjustment

Attach The Water Supply Hose To The Stop Valve

Lift the toilet assembly and install

by assemblings the outlet edge of

waste connector with the waste inlet

as the mark defined.

Attach the water supply hose properly

to the water control valve of the tank.

And then tighten snugly by hand.

Attach the water supply hose to

the stop valve. And then tighten

snugly by hand. Turn on the water

to test for leakage occurs, use a

wrench to tighten the connection

carefully untill the leakage stops.

Adjust the water level in the tank to

point indicated on the tank wall,

as shown in the picture.

Gather all the components first. Insert the rubber gasket

in the water outlet hole, then place the tank over it,

ensuring a secure fit. Next, place a rubber washer on

each of the 2 bolts and insert these through their respective

holes. Place the washer and the nut on the end of the bolt

tighten alternately one side, then the other untill snug. Be

sure the tank is level. Do not tighten the nuts too much.

it will break the vitreous china.

After the installation with above

instruction, check the levelness

with the use of level gauge from

side to side (left & right)

The picture shows

the completely connector

into toilet.

Fixing the toilet with the floor

By using the screw with the floor fixing set

(supplied)

¹Ó¶Ñ§¾Ñ¡¹éÓ·Õè»ÃÐ¡ÍºÍØ»¡Ã³ì¶Ñ§¾Ñ¡¹éÓàÃÕÂºÃéÍÂáÅéÇ µÒÁÇÔ¸Õ¡ÒÃ·Õèá¹Ð¹Ó

äÇéÊÓËÃÑºÍØ»¡Ã³ìÃØè¹¹Ñé¹æ â´Â¡ÒÃãªé¹çÍµÂÖ´ÃÐËÇèÒ§ÃÙ¶Ñ§¾Ñ¡¹éÓáÅÐâ¶ÊéÇÁ

´éÒ¹ã¹â´ÂÁÕÂÒ§ÃÍ§¶Ñ§¾Ñ¡¹éÓµÃ§µÓáË¹è§·Ò§¹éÓÅ§¢Í§¶Ñ§¾Ñ¡¹éÓ ¢Ñ¹¹çÍµ

ÂÖ´ÊÅÑº¡Ñ¹ 2 ¨Ø´ ´éÇÂÁ×Í¨¹á¹è¹ áÅÐãªé»ÃÐá¨¢Ñ¹ÂÖ´¹çÍµ·Ñé§ 2 ¨Ø´

ÍÕ¡¤ÃÑé§ ¤ÇÃÃÐÇÑ§¡ÒÃ¢Ñ¹á¹è¹à¡Ô¹ä» à¾ÃÒÐ¨Ð·ÓãËé¶Ñ§¾Ñ¡¹éÓáÅÐâ¶ÊéÇÁ

ºÃÔàÇ³¹Ñé¹áµ¡ä´é áÅÐ¤ÇÃãËé¶Ñ§¾Ñ¡¹éÓä´éÃÐ´ÑºäÁèàÍ¹àÍÕÂ§

Install The Toilet Seat (See the manual for installing Seat&Cover)

Install the toilet seat

and apply silicone sealant

around the bowl.

1
2
3
4
5
6
7

American Standard TONIC 3/6 Lpf Installation guide

American Standard

Brand: American Standard

Model: TONIC 3/6 Lpf

Type: Installation guide

This manual is also suitable for

TF-3104

Download PDF

Related papers

Other documents