Alphalite WPA-15B Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Alphalite WPA-15B Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
10715 Springdale Ave, Ste 4, Santa Fe Springs, CA 90670 l Tel: 1-888-287-9228 l Fax: 1-888-258-9183 l E-mail: [email protected]
Installation Instructions
LED Wall Pack
Installation guide valid for the following models:
WPA-15B WPA-60B
WPA-24B WPA-80B
WPA-42B
WARNING
RISK OF ELECTRIC SHOCK.
Disconnect power at fuse or circuit breaker before installing or servicing.
WARNING
RISK OF FIRE OR ELECTRIC SHOCK.
The LED Wall Pack must be installed by a qualied electrician in accordance with applicable
federal, state, and local laws and codes. Installation requires knowledge of luminaire electrical
systems and installer should be familiar with the operation of this product. If not qualied, do not
attempt installation; contact a qualied electrician. Manufacturer assumes no responsibility for the
improper installation of this luminaire.
WARNING
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp
objects. When installing this kit, drilling may damage luminaire wiring and electrical parts. Check for
wiring and components in enclosure before drilling.
NOTE
Only those open holes indicated in the photographs and/or drawings may be made or altered as
a result of kit installation. DO not leave any other open holes in an enclosure of wiring or electrical
components.
NOTE
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or any shape
objects.
Contact manufacturer with any questions or concerns regarding installation of this luminaire.
1
10715 Springdale Ave, Ste 4, Santa Fe Springs, CA 90670 l Tel: 1-888-287-9228 l Fax: 1-888-258-9183 l E-mail: [email protected]
1. Fasten the template A to the wall using appropriate fasteners.
2. Mount the xture to template A through part B.
3. Fasten the 2pcs fasteners through the holes aside, and make sure they rmly
touch the template A.
Wiring Guide
1. Mount the junction box to the wall, wire connections must be within the junction box (see g. 1).
2. Knock out opening (C) in bottom casting, for conduit mount (see g. 2).
Fig. 1 Fig. 2
Installation Instructions
LED Wall Pack
2
A
B
C
Fasteners
/