Fire Magic Island Enclosure Spacer Kit User manual

L-C2-620

REV 0 - A - 1912041145

This spacer kit is used to give additional support to the hangers, maintain an even air gap around the

cutout, and prevent the unit from sliding. Kit model AD-G20 (3 pcs) is designed for use with grills and AD-

SB20 (2 pcs) is for side cookers. To install; follow the steps below:

1. Completely read and follow the grill owners's manual for enclosure installation.

2. Place a panel onto the left sidewall of the countertop cutout. The panel must be ﬂush with the front edge

of the cutout, and ﬂush with the countertop surface. See Fig. 1-1. Fasten the panel using the appropriate

hardware (not included).

3. Repeat for the right sidewall of the countertop cutout.

4. Place the 3rd panel (if equipped) to the rear wall of the countertop cutout. The panel must be centered

from left to right and ﬂush with the countertop surface. See Fig. 1-1. Fasten the panel using the appropriate

hardware (not included).

5. Refer to the instructions provided with your grill or side cooker for its installation.

INSTALLER: Leave these instructions with consumer.

CONSUMER: Retain for future reference.

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

ISLAND ENCLOSURE

SPACER KIT

Model # AD-G20

AD-SB20

AD-G20

kit shown

Flush with

front edge

of cutout

Overhang

Fig. 1-1

AD-G20

kit

Flush with

countertop

surface

AD-SB20

kit