Ke y l e s s en t r y
To program the Keyless Entry system, press the
INFO
button, then select
SET
.
lo c K si g n a l
The LOCK SIGNAL noties you that the door is locking
or unlocking by ashing the hazard warning lights. Select
or deselect the BACK ANSWER key to activate or
deactivate this function.
to u c h
To adjust the TOUCH PANEL sensing positions, press
the
INFO
button, then select
RESET
, and the
button. Then touch the center of the lower
left crossmark
.
Selecting or deselecting BEEP turns the beep sound
on or off.
You can program the monitor system for other display
items and answer back beeps that let you know the
door is locking. To use, press the
INFO
button and
then select
SET
. The screen for mode of function
will be displayed.
Selecting or deselecting CLOCK turns the time on or
off the screen.
Selecting or deselecting OUT TEMP turns the outside
temperature display on the screen on or off.
ro o m l a m P (i n t e r i o r l i g h t )
Roomlamp allows you to choose the delay time before
the interior light turns off when the doors are unlocked
using the keyless entry system transmitter, or when the
doors are closed.
De f o g g e r
Defogger can be programmed for two operation modes:
continuous and 15-minute. When the continuous
operation mode is programmed, the rear window
defogger will operate for 15 minutes, stop for 2 minutes,
and operate again for 15 minutes, and so on. In the
15-minute mode, the defogger will automatically shut
off after 15 minutes. You can shut if off before that time
if you press the rear window defogger switch again.
De i c e r
Deicer can be programmed for the same two operation
modes: continuous and 15-minute. In continuous operation
mode, when the windshield wiper deicer is pressed, the
deicer will continue to function. In the 15-minute mode,
the windshield wiper deicer will automatically shut off
after about 15 minutes. Pressing the switch again will
shut if off before that time.
For complete information on your Multi-Information Display, please consult your Owner’s Manual.