Contec PCE37/9PS is a connection conversion cable for Serial I/O. It converts the CN1 (37-pin D-SUB connector) on the board of Serial I/O to 9-pin D-SUB male connectors for four channels. This allows you to connect four RS-232C or RS-422A/485 devices to your computer. The cable is 250mm long and weighs 200g. It has a 37-pin D-SUB male connector on one end and four 9-pin D-SUB male connectors on the other end. The cable is shielded to protect against electromagnetic interference.
Here are some of the possible use cases for the Contec PCE37/9PS:
Contec PCE37/9PS is a connection conversion cable for Serial I/O. It converts the CN1 (37-pin D-SUB connector) on the board of Serial I/O to 9-pin D-SUB male connectors for four channels. This allows you to connect four RS-232C or RS-422A/485 devices to your computer. The cable is 250mm long and weighs 200g. It has a 37-pin D-SUB male connector on one end and four 9-pin D-SUB male connectors on the other end. The cable is shielded to protect against electromagnetic interference.
Here are some of the possible use cases for the Contec PCE37/9PS:
Contec PCE37/9PS is a connection conversion cable for Serial I/O. It converts the CN1 (37-pin D-SUB connector) on the board of Serial I/O to 9-pin D-SUB male connectors for four channels. This allows you to connect four RS-232C or RS-422A/485 devices to your computer. The cable is 250mm long and weighs 200g. It has a 37-pin D-SUB male connector on one end and four 9-pin D-SUB male connectors on the other end. The cable is shielded to protect against electromagnetic interference.
Here are some of the possible use cases for the Contec PCE37/9PS:
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI