2. Digitus
  3. DN-FC-9100

Digitus DN-FC-9100 Quick start guide

  • I have reviewed the provided document for the DIGITUS SC Fiber Optic Fast Connector. It appears to be a user manual focusing on the field assembly of the connector, detailing the tools and steps involved. The manual also specifies its applications, including use in ODF, ONT, FTTH, and Cable TV networks alongside its performance characteristics. I am ready to answer your questions about the product.
  • What is the average insertion loss?
    What is the average return loss?
    What applications is this product for?
SC Fiber Opc Fast Connector
Field Assembly
Product Content
Prefabricated Opcal-Fiber
Tools
Instrucons
Thank you very much for purchasing our products. Please
read the instrucons carefully before using.
• Applicaon: ODF (Opcal Distribuon Frame), ONT
(Opcal Network Unit), FTTH (Fiber To The Home), and
Cable TV Network
• Average inseron loss: ≤ 0.2 dB
• Average return loss: ≥ 50 dB
Connector SC/APC
SC/UPC
55 mm x 8.9 mm x 7 mm
Cable Stripper
Mulfuncon Marker
Miller Clamp
Opcal Fiber Cleaver
Ø (0.125 mm) Ø (0.25 mm)
Fiber coang
12 mm 17 mm
Fiber cable
1 2
Operaonal Procedure Pre-Operaonal Procedure
Noce: Please assure the product and ber are
clean during these procedures.
For Reusing
A: Push against the dust cap and get o shell
B: Push back and loose the opcal ber
C: Twist the tall set, pull out the ber cable
① Use the cable stripper, cut the cable
about 45 mm
② + ③ Put the cable in the ber cung marker,
use miller clamp, peel the ber coang
then clean it and check it
④ Cut the ber by cleaver and make sure
it is in good condion
⑤ Check and nish.
1. Penetrate the tail set into ber cable.
2. Get the prefabricated opcal ber inserted,
push and make it inect
Get stuck
Make inect
3. Push and lock it, close the end cap.
Push
Tighten it
4. Screw ghtly
45 mm
10 mm
20 mm
WARNING:
Please don‘t look directly
at the laser signal.
34
/