WaterWorks HNSF24 Installation guide

WaterWorks
Brand
WaterWorks
Model
HNSF24
Type
Installation guide

This manual is also suitable for

PRODUCT SUPPORT | 800.927.2120 | WATERWORKS.COM PAGE 1 OF 2 | UPDATED ON 8.04.2023
INSTALLATION GUIDELINES
WALL MOUNTED ACCESSORIES
3. Dry-fit the product to the finished wall and mark
the ideal location making sure to hold the product
level.
NOTE: Verify the on-center spread, Dimension “A”.
2. LOOSELY assemble both the SHELF BRACKETS
onto the GLASS making sure to use the O-RINGS
provided to prevent damage.
HENRY AND REGULATOR GLASS SHELF IMPORTANT:
¾To ensure this product is installed properly, you must read and follow these
guidelines.
¾The owner/user of this product must keep this information for future reference.
¾This product must be installed by a professional licensed contractor.
¾Inspect this product to ensure you have all the parts required for proper
installation.
¾Use only a strap wrench or protected/smooth-jaw wrench on any finished surface.
¾DRYWALL ANCHORS for a typical drywall installation are provided. Do NOT use
the ANCHORS if mounting directly onto wood blocking or a stud.
¾If further assistance is required, please contact Product Support at 1-800-927-
2120 Monday through Friday, 8am – 6pm EST.
¾Refer to the separate Service Parts Documents for available replacement parts.
STYLES
HNSF24 RGSF18
SHELF BRACKET
MOUNTING PLATE
SET SCREW
[2mm HEX]
SHELF BRACKET
O-RING
MOUNTING
HOLE
GLASS
O-RING METAL WASHER
FINISHED SCREW
"A"
ON-CENTER
FINISHED
WALL
GLASS
[HOLD LEVEL]
* DRY-FIT AND MARK LOCATION
HNSF24: "A" = 20" [508mm]
RGSF18: "A" = 18" [457mm]
1. Loosen, but do NOT remove, the SET SCREW on
the bottom of each SHELF BRACKET using a 2mm
HEX KEY and remove the MOUNTING PLATES.
PRODUCT SUPPORT | 800.927.2120 | WATERWORKS.COM PAGE 2 OF 2 | UPDATED ON 8.04.2023
INSTALLATION GUIDELINES
WALL MOUNTED ACCESSORIES
5. Place the BRACKETS over the MOUNTING PLATES
and securely tighten the SET SCREWS and
FINISHED SCREWS.
4. Using the previous marks as a reference, install
the MOUNTING PLATES using the SCREWS and
ANCHORS provided.
CAUTION: Ensure the MOUNTING PLATES are level
and at the desired on-center spread, Dimension
“A”.
WOOD SCREW
DRYWALL ANCHOR
MOUNTING PLATE
"A"
ON-CENTER
MOUNTING
PLATE
SET SCREW
[2mm HEX]
FINISHED
SCREW
SHELF
BRACKET
  • Page 1 1
  • Page 2 2

WaterWorks HNSF24 Installation guide

WaterWorks
Brand
WaterWorks
Model
HNSF24
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents