Rugged Ridge 11232.76, 11232.74, 11232.75 Installation guide

Hello, I'm your chat assistant. I have reviewed the installation instructions for the Rugged Ridge Rear LED Cube Mounts, models 11232.75 and 11232.76. This document details the components for both the left and right sides and provides a step-by-step guide for mounting the brackets to your Jeep's bumper. I'm ready to answer your questions about the installation process.
What is included for the LH (passenger side) mount?

What is included for the RH (driver side) mount?

Where do the bumper bolts go?

What hardware is used to connect the upper and lower brackets?

460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 844-270-0593 | www.Omix-ADA.com

Rugged Ridge Rear LED Cube Mount, RH or LH, JL

Page 1/2

Part #11232.75, 11232.76

OMIX-ADA® TECHNICAL SUPPORT

PHONE: M-F 8am - 5pm EST 1-800-449-6649

FOR WARRANTY OR TECH CONCERNS EMAIL: [email protected]

Components for 11232.75, LH (passenger side)

Components for 11232.76, RH (driver side)

1. Upper Light Bracket ................................................................. 1

2. Lower Light Bracket .................................................................. 1

3. Carriage Bolts ........................................................................... 2

4. Serrated Flange Nuts ............................................................... 2

1. Upper Light Bracket ................................................................. 1

2. Lower Light Bracket .................................................................. 1

3. Carriage Bolts ........................................................................... 2

4. Serrated Flange Nuts ............................................................... 2

460 HORIZON DR. | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 844-270-0593 | www.Omix-ADA.com

Rugged Ridge Rear LED Cube Mount, RH or LH, JL

Page 2/2

Part #11232.75, 11232.76

2. Now feed the upper bracket between the bumper

and body. Once you have the upper and lower

bracket meeting attach the two items with the

provided carriage bolts and serrated ange nuts.

Fully tighten all hardware.

Now install the Light of your choice to the bracket.

Follow light instructions to properly install.

1. First move to underneath your Jeep at the rear

bumper. Remove the two bumper bolts located on

the side of the frame rail. Now install the lower light

bracket to this location and use the OE bolts through

the bracket back to the frame-rail.