ICON Vehicle Dynamics Front Driveshaft is designed to work with up to 4.5” of lift. The driveshaft is intended to be installed on the 2007-2011 Jeep Wrangler JK. The driveshaft's transfer case yoke is equipped with new O-ring that needs to be transferred from the old flange. The driveshaft connects to the transfer case using the supplied 5/16” hardware. Installation requires the 4WD to be engaged and may require disengaging the 4WD to connect to the differential, and may require trimming of the factory skid plate.
ICON Vehicle Dynamics Front Driveshaft is designed to work with up to 4.5” of lift. The driveshaft is intended to be installed on the 2007-2011 Jeep Wrangler JK. The driveshaft's transfer case yoke is equipped with new O-ring that needs to be transferred from the old flange. The driveshaft connects to the transfer case using the supplied 5/16” hardware. Installation requires the 4WD to be engaged and may require disengaging the 4WD to connect to the differential, and may require trimming of the factory skid plate.
ICON Vehicle Dynamics Front Driveshaft is designed to work with up to 4.5” of lift. The driveshaft is intended to be installed on the 2007-2011 Jeep Wrangler JK. The driveshaft's transfer case yoke is equipped with new O-ring that needs to be transferred from the old flange. The driveshaft connects to the transfer case using the supplied 5/16” hardware. Installation requires the 4WD to be engaged and may require disengaging the 4WD to connect to the differential, and may require trimming of the factory skid plate.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI