Page is loading ...
Instructions for Recirculation Kits
This pack includes:
A. 8 X screws
B. 1 X damp er
C. 2 X clamps
D. 1 X recirculation box
E. 1 X extension tube (150mm*1.5m; 6” x 4’ )
F. 2 X round carbon filters or 1 X square carbon filter or 2 X round carbon filters without handles
Installation:
1. Step 1:
a) .dedivorp )A( swercs eht fo 4 gnisu )D( xob noitalucricer eht no )B(repmad eht xiF
. .1 erugiF eeS
2. Step 2:
a) Connect the extension tube (E) to the damper on top of the range hood using one
of the clamp provided (C) to tighten the tube around the recirculation box (D).
b) llatsni )D( xob noitalucricer eht ot )E( ebut noisnetxe eht tcennoC
ed eht gnisu 1 petS ni
.2 erugiF eeS .)C( pmalc rehto
3. Step 3:
Adjust the length of the extension tube, and put the chimney on the body, then fix the
recirculation box on inside chimney with 4 screws (A). See Figure 3.
a)
4. Step 4:
a) Attach the 2 X round carbon filters or 1 X square carbon filter (F) onto the range hood.
See Figure 4.
E
F
2 X
OR
1 X
A B C
D
OR
2 X
Figure 1
Figure 2
Figure 3
Figure 4
OR/
OU
/