Page is loading ...
F
EATURES
:
• Designed for use on a tabletop
• Extruded aluminum post
• Heavy tempered glass base provides increased
stability and helps minimize resonances
• Openings in center and bottom of post allow for
hidden speaker cable
• Self-adhesive rubber feet
High-performance speaker stands are
essential in any high-quality audio/home
theater system. Elegant and solidly
constructed PREMIER
™
LS-Series
stands position speakers at ear level to
ensure the best performance possible.
Paradigm Electronics Inc., and its representatives,
agents or retailers assume no responsibility or liability
for any damage or injury arising from the use of these
speaker stands.
ASSEMBLY INSTRUCTIONS
LS-15
SPEAKER STAND
Parts List (pair)
2 Extruded Aluminum Posts
with Mounting Brackets attached
2 Plastic End Caps
2 Tempered Glass Bases
4 Hex Screws
8 Self-Adhesive Rubber Feet
4 Stainless Steel Washers
4 Plastic Washers
1 Hex Key
IMPORTANT! Stand must be wired with speaker cable before assembling (see over)
Mounting Cinema
™
330
Assemble base as shown using
stainless steel washers with hex screws
Mounting Cinema
™
220
Assemble base as shown using
plastic
washers with hex screws
1. Attach bracket
hanging screws
(included with
speaker) to back
of speaker so they
protrude about
1/8 inch (3 mm).
2. Attach rubber
bumper pads
(included with
speaker) to bottom
rear of speaker.
3. Aligning screws
to bracket holes,
mount speaker on
bracket with an
in-and-down motion.
4. If speaker mounting
is loose, remove
speaker from stand,
tighten hanging
screws slightly and
remount. Repeat
until mounting is firm.
1. Insert speaker
hanging screws
(included with
speaker) through
holes in back of
post, as shown.
Attach stainless
steel washers.
2. Insert screws into
60-mm holes on
back of speaker
and screw in until
mounting is firm.
WIRING INSTRUCTIONS
PRM003 Rev1
PARADIGM ELECTRONICS INC.
Sales and Marketing U.S.
MPO Box 2410
Niagara Falls, NY 14302 U.S.A.
T.905 632-0180 F.905 632-0183
Sales and Marketing Canada
205 Annagem Blvd., Mississauga ON
Canada L5T 2V1
T.905 564-1994 F.905 564-8726
1. Remove bracket using Philips screwdriver. Remove end cap.
2. Feed cable through opening in top of post until it comes out of
the bottom.
3. Feed cable through hole in bottom rear of post.
4. Pull cable through hole in top front of post. Make sure there is
enough cable hanging out to attach speaker. Replace end cap.
• For Cinema
™
330: Feed cable through bracket then
reattach bracket.
• For Cinema
™
220: Bracket not required.
Step 4
Step 3
Step 2
Step 1
Reattach bracket:
CINEMA
™
330 only
/
