Nesco FS-250 Owner's manual

Brand: Nesco

Model: FS-250

Category: Slicers

Type: Owner's manual

Nesco FS-250 is a versatile food slicer capable of slicing a variety of foods with precision and ease. Featuring a powerful 180W motor and a reinforced, non-rusting fine blade, it can effortlessly slice meats, cheeses, vegetables, and fruits. With adjustable slice thickness settings ranging from deli-thin to 9/16 inches, you can customize the thickness of your slices to suit your preference. The food carriage and slicing guard ensure safe and controlled operation, while the compact design and easy-to-clean components make it a breeze to use and maintain.

Page is loading ...

English

IMPORTANT SAFEGUARDS

THIS PRODUCT IS DESIGNED FOR HOUSEHOLD USE ONLY. When using electrical

appliances, basic safety precautions should always be followed, including the following:

1. READ ALL INSTRUCTIONS.

2. Do not touch hot surfaces. Use handles or knobs.

3. To protect against electrical shock and personal injury, do not immerse this appliance,

including cord and plug, in water or other liquid.

4. This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless they

have been given supervision or instruction concerning use of the appliance by a person

responsible for their safety.

5. Close supervision is necessary when any appliance is used by or near children.

6. Unplug from outlet when not in use and before cleaning. Allow to cool completely before

putting on or taking off parts, and before cleaning.

7. Do not operate any appliance with a damaged cord or plug or after the appliance

malfunctions or has been damaged in any manner. To avoid hazards, return appliance to

NESCO® Factory Service Department for examination, repair or adjustment.

8. The use of accessory attachments not recommended by the manufacturer may result in

re, electric shock or injury to persons.

9. Do not use outdoors.

10. Do not let cord hang over edge of table or counter, or touch hot surfaces.

11. Do not place on or near a hot gas or electrical burner or in a heated oven.

12. Do not use appliance for other than its intended use, as described in this manual.

13. Operate appliance only when all parts are fully engaged and secured.

14. Do not operate the appliance continuously for more than 10 minutes. Allow the appliance

to cool down for one hour before second operation.

15. Do not use appliance to cut deep frozen food or bones.

16. Operate appliance only when Blade Locking Screw is properly engaged and tightened.

17. Handle Blade carefully when cleaning, removing and inserting, as blade is extremely

sharp. Do not touch sharp edge of Blade.

18. Be careful, the Blade continues to turn for a while after the appliance has been turned off.

19. To avoid danger of injury, always cut food with this appliance fully assembled. The Food

Carriage and Slicing Guard must always be used.

20. Adjust the supporting plate to position “0” after use and before cleaning..

SAVE THESE INSTRUCTIONS

Polarized Plug: This appliance has a polarized plug (one blade is wider than the other). To reduce risk of

electric shock, plug is intended to t into polarized outlet only one way. If the plug does not t fully into

the outlet, reverse the plug. If it still does not t, contact a qualied electrician. Do not try to modify the

plug in any way.

Short Cord Instructions: A short power supply cord is provided to reduce the risk resulting from

becoming entangled in or tripping over a longer cord. Extension cords may be used if care is exercised in

their use. If an extension cord is used, the marked electrical rating of the cord should be at least as great

as the electrical rating of the appliance. The longer cord should be arranged so that it will not drape over

the tabletop where it can be pulled on by children or tripped over unintentionally.

English

FEATURES

BEFORE FIRST USE

1. Read and understand all instructions and components described in this manual. Keep for

future reference.

2. Remove all packaging and save for storage.

3. Remove and wash the Blade, Food Carriage and Slicing Guard in warm soapy water.

(follow Care and Cleaning Instructions).

4. Wipe the Base with a damp cloth. DO NOT IMMERSE THE BASE IN WATER OR ANY

OTHER LIQUID! (follow Care and Cleaning Instructions).

OPERATION

1. Place appliance on a at, dry and stable surface.

2. Be sure power switch is ‘OFF’, then plug into a standard 120V AC electrical outlet.

3. Place a suitable tray or plate behind slicer to collect the sliced food.

4. Place food onto food carriage between support plate and slicing guard. To avoid danger of

injury, always use food carriage and slicing guard while cutting.

5. Adjust the slice thickness by turning the thickness control to desired thickness between 0

and 12 (Deli thin to 9/16”).

6. Slide food carriage back so food is clear of blade. Press power switch to start the slicer.

Keep left hand clear, place near the power switch, and grasp the slicing guard with the

other hand.

7. To begin slicing, push food in towards support plate while holding the slicing guard and

slide food into blade. Slide food carriage back and repeat until you have sliced the desired

amount of food.

8. When nished, press power switch to turn OFF unit. Note: Blade will continue to move

for a short time. Always keep hands away from blade! Remove plug from electrical

outlet before cleaning.

9. For safety, always return thickness control to ‘P’ after use to shield sharp edge of blade

during storage.

SUPPORT

PLATE

BLADE LOCKING

SCREW

BASE

BLADE

POWER

SWITCH

THICKNESS

CONTROL

CARRIAGE

ROD RELEASE

FOOD

CARRIAGE

SLICING GUARD

CARRIAGE

ROD

English

CARE AND CLEANING INSTRUCTIONS

1. Always unplug the appliance from electrical outlet before cleaning.

2. Never immerse the base of this appliance in water or other liquid.

3. The blade, slicing guard and food carriage can all be removed and hand washed in warm

soapy water. Be careful when cleaning the blade, as it is extremely sharp. Do not leave

blade under water; trying to handle sharp objects in water can be hazardous.

4. Set thickness control to “P”. This will keep the blade edge covered by support plate.

5. For ease of cleaning, the food carriage can be tilted up or completely removed.

6. Remove blade by holding the blade with one hand and using two ngers to pinch and turn

blade locking screw. Unlock blade by turning screw clockwise. Carefully remove blade

and hold by using the blade locking screw.

7. Clean outer surfaces with a damp cloth. Mild detergent or plain water can be used to

dampen cloth. Never immerse base in water or any other liquid. Do not use steel wool,

abrasive cleaners or sharp utensils to clean any part of this appliance.

8. After cleaning and drying, install blade to base in reverse order of Step 6. Carefully place

blade on mating hub of motor. Align the locking screw tabs with the mating slots in the

hub of motor and press in until seated. Rotate locking screw counter-clockwise until

seated to lock blade in place.

CARRIAGE TILT BLADE REMOVAL

CARRIAGE REMOVAL

English

ONE YEAR LIMITED WARRANTY

This appliance is warranted for one year from date of original purchase against defects in

material and workmanship. This warranty does not cover transportation damage, misuse,

accident or similar incident. This warranty gives you specic legal rights and you may have

other rights, which vary from state to state. This product is intended for household use only,

not for commercial use. Warranty does not cover commercial use.

Your new NESCO

appliance comes equipped with numerous safety features. Any attempt

to interfere with the operation of these safety features makes this warranty null and void. In

the event we receive an appliance for service that has been tampered with, we reserve the

right to restore it to its original state and charge for the repair.

For service in warranty - Defective products may be returned, postage prepaid, with a

description of the defect to: The Metal Ware Corporation, 1700 Monroe Street, Two Rivers,

Wisconsin 54241, for no-charge repair or replacement at our option.

Must include proof of purchase or copy of original bill of sale when returning product for

warranty service.

Please call Customer Satisfaction at 1-800-288-4545 to obtain a Return Authorization before

shipping.

• For service in warranty, follow instructions set forth in warranty. When ordering new

parts, make sure that you always mention the model number of the product.

• Call us on our toll free number, 1-800-288-4545 and tell us about your problem.

• If we instruct you to send all or part of your appliance to us for repair or replacement,

our Customer Satisfaction representative will provide a Return Authorization number

(this number noties our receiving department to expedite your repair). Pack your unit

carefully in a sturdy carton with sufcient padding to prevent damage because any

damage caused in shipping is not covered by the warranty.

• Print your name, address and Return Authorization number on the carton.

• Write a letter explaining the problem. Include the following: your name, address and

telephone number and a copy of the original bill of sale.

• Attach the sealed envelope containing the letter inside the carton. Insure the package for

the value of the NESCO

appliance and ship prepaid to:

Attn: Factory Service Dept.

The Metal Ware Corporation

1700 Monroe Street

Two Rivers, WI 54241

Page is loading ...

1 - 800 - 288 - 4545

Nesco FS-250 Owner's manual

Brand: Nesco

Model: FS-250

Category: Slicers

Type: Owner's manual

Download PDF

report

in other languages

français: Nesco FS-250 Le manuel du propriétaire
español: Nesco FS-250 El manual del propietario

Nesco FS-250 Owner's manual

Nesco FS-250 Owner's manual

in other languages

Related papers

Other documents