Meade Handbox Holder for 16" scopes Owner's manual
- Category
- Telescopes
- Type
- Owner's manual
This manual is also suitable for
Introduction
The Handbox holder attaches to the base of your 16"
RCX telescope and holds the Autostar handbox in a
convenient position. The handbox holder is comprised
of two parts: A bolt and a clamp (Fig. A).
To attach the Handbox Holder:
1. Slide the bolt through the hole in the wide end of
the clamp.
2. Thread the bolt into the hole provided on the base
of the RCX, but do not tighten yet (Fig. B).
Position clamp at an angle that is comfortable for
you and then tighten the bolt to a firm feel.
If you have a question concerning use of the Meade HANDBOX
HOLDER
, call the Meade Instruments Customer Service Department
at (800) 626-3233. Customer Service hours are 8:00 AM to 5:00 PM,
Pacific Time, Monday through Friday.
Operating Instructions
The Meade
®
Handbox Holder
For use with Meade 16" RCX400 Telescopes
Ver. 12-06
(800) 626-3233
www.meade.com
Fig. A: Handbox holder: The bolt and the clamp.
Fig. B: Thread the bolt through the wide end of the
clamp and into the base of the RCX telescope.
wide
end of
clamp
-
1
Meade Handbox Holder for 16" scopes Owner's manual
- Category
- Telescopes
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Meade RCX400 Owner's manual
-
-
-
-
Meade LS (LightSwitch) Series User manual
-
-
-
-
-
