To select an auto-scan mode:
1. Hold down the F6 button for about 2 seconds, then release. Note
that the last chosen mode flashes in the screen.
2. While the mode flashes, perform quick, short presses of the F6
button to select alternate modes.
SHORTWAVE WITH THE E5
SHORTWAVE NOTE: If you’re completely new to shortwave or need
a ‘refresher’, see the special shortwave section toward the end of this
manual.
There are two ways to select shortwave.
1. Sequentially press the ‘METERBAND’ button (10) until the short
wave band of your choice is selected.
2. The seven most popular shortwave bands can also be accessed
with the F1-F7 buttons (F1=49m, F2=41m, F3=31m, F4=25m,
F5=22m, F6=19m and F7=16m). In each method, the last used
frequency is automatically displayed. To tune-in shortwave stations,
use the tuning methods described earlier. Below is a band chart
showing the G5’s shortwave coverage.
G5 SHORTWAVE COVERAGE AND TUNING SUGGESTIONS
The G5 has continuous frequency coverage from 150 to 29999
kilohertz (kHz). This includes Longwave (150-519 kHz), Medium Wave
(the AM broadcast band (520-1710 kHz) and Shortwave (1711-29999
kHz). To go to a specific shortwave frequency, use the direct-frequen-
cy-entry tuning method. When searching for shortwave stations in
an international broadcast band, use manual tuning, the tuning knob
(40) or auto tuning. Direct-frequency- entry, manual tuning and use of
the tuning knob enable tuning anywhere in the shortwave spectrum.
Auto-tuning scans only within the designated frequency limits of
5 BASIC RADIO OPERATION continued
G5 OWNER’S MANUAL
G5 OWNER’S MANUAL
17