2. horiba
  3. LAQUAact D-74

horiba LAQUAact D-74 Quick Manual

  • Hello! I am an AI chatbot trained to assist you with the horiba LAQUAact D-74 Quick Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CODE
:
GZ0000340568A
March, 2015 © 2013 - 2015 HORIBA, Ltd.
Quick Manual
Portable pH/Conductivity Meter D-74
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
Preparation
Press the power key of the meter
Connect the electrode to the meter
Change the measurement parameter to conductivity
MEASCAL DATA
LIGHT
SETMODE
ENT
Press or
Press
http://www.horiba-water.com
Temperature connectorElectrode connector
Conductivity measurement
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
×
3
MEASCAL DATA
LIGHT
SETMODE
ENT
Start the measurement
Enter the set up mode Enter the measurement mode Set the cell constant
Press
Set the cell constant
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
Immerse up to
the hole in the
lower part of
the cell.
Press
When changes from the blinking state
to the lit state, measurement is complete.
Press three times
Press
Press
Measurement
When the batteries run out or the meter will not be used
for a long period, remove the batteries.
NOTE
MEASCAL DATA
LIGHT
SETMODE
ENT
MEASCAL DATA
LIGHT
SETMODE
ENT
3552-10D
1.065 × 100 m
-1
1 cm
-1
)
Check the label on the electrode.
Example)
Press to set the digit
number of cell constant.
Register it with .
Press to set the number
of cell constant.
Change the digit with .
Register it with .
To measurement
Press to reect the changes.
/