Antennas Direct C1-C ClearStream 1 Convertible Assembly Instructions

  • Hello! I am an AI chatbot trained to assist you with the Antennas Direct C1-C ClearStream 1 Convertible Assembly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
C1-C ClearStream 1 Convertible
Assembly Instructions
The ClearStream 1 Convertible Comes with:
Reector and Mast Clamp (A)
Element (B) and Base (C)
Center Bar (D)
4 1/2”Bolt
Assembly for Indoor Use
Insert center bar into underside of base.
Fig. 1
Fig. 2
Back of element
Antenna Base
Locate the circle and triangle symbols on the element and base.
Fig. 3
Desk Top
Fig. 4
Wall Mount
After lining up triangle and circle symbols
rotate the base clockwise unil it locks in
the desktop position.(Figure 3)
For the wall or outdoor positions continue
to rotate clockwise until base locks in the
horizontal position (Figure 4)
2 Meter cable
Weather Boot
Wall mount hardware
A
B
C
n
t
t
n
The Clearstream Convertible has three possible congurations:
Table mount , Wall mount or Outdoor mast mount
Fig 3
D
Assembly for Outdoor Use
Due to the higher frequencies used by digital broadcasters, mounting an antenna outdoors will offer greater performance
Line up circle and triangle on base to matching
symbols on element.
Insert Base C into element assembly B and turn to
the left toward the picture as in Figure 7.
Rotate base to tighten onto element. DO NOT
OVER TIGHTEN.
Center Groove
Attach the reector (grid) to the antenna base by threading
the 4 1/2” bolt through the center of the column. Tighten.
Attach antenna to mast using u-clamp.
Attach coaxial cable to F connector.
DO NOT OVER TIGHTEN
Aluminum Bar
U-Clamp
Base
Reector Grid
U-Clamp
F connector
Cable
Align center groove of base (Figure 5) with
the aluminum bar on the reector (Figure 6).
Fig. 6
Fig. 5
877-825-5572
1699 West Fifth Street
Eureka, MO 63025
www.antennasdirect.com
Helpful Tips:
• Ifyourcablerunisgreaterthan75’,Apre-ampliermayberequired.
• UHFsignalsarelineofsight.Getasmuchelevationaspractical.
• AtticInstallationswillcut40%-50%ofyoursignalstrength.
• KEEP ANTENNA AWAY FROM POWER LINES
/