Western Poly Hopper Spreader Collar (2.5 Cu. Yd.) Serial #0905-Higher #78006/78007/78008 Installation guide

Western
Brand
Western
Model
Poly Hopper Spreader Collar (2.5 Cu. Yd.) Serial #0905-Higher #78006/78007/78008
Category
Car kits
Type
Installation guide
Lit. No. 78248, Rev. 00 1 February 1, 2010
POLY HOPPER SPREADER COLLAR
A DIVISION OR SUBSIDIARY OF DOUGLAS DYNAMICS, L.L.C.
INSTALLATION INSTRUCTIONS
1. Remove both lids from the hopper body by pulling
out all D-ring pins and washers. Slide the lids back
towards the chute and off the hopper body.
2. Remove the screens and screen supports from
the hopper body.
3. Place the collar on top of the hopper body with
the lid hinge posts in the same orientation on the
collar as the hopper body.
4. Fit the collar tightly to the hopper body, minimizing
all gaps.
5. Drill a 3/8" clearance hole through the collar only,
in-line with the lid hinge posts and about 1-1/2"
above the bottom of the collar. Repeat at each lid
hinge post location, for a total of six drilled holes.
1-1/2"
Drill 3/8" Hole
Lid Hinge Posts
Collar
CAUTION
Before drilling any holes, check both sides
of the material for any wires, fuel lines, fuel
tanks, etc. that may be damaged by drilling.
POLY HOPPER SPREADER COLLAR
Lit. No. 78248, Rev. 00 2 February 1, 2010
The company reserves the right under its product improvement policy to change construction or design details and furnish equipment when
so altered without reference to illustrations or specifi cations used. This equipment manufacturer or the vehicle manufacturer may require or
recommend optional equipment for spreaders. Do not exceed vehicle ratings with a spreader. The company offers a limited warranty for all
spreaders and accessories. See separately printed page for this important information.
Printed in U.S.A.
6. Secure using the supplied lag bolts with the lock
washers between the fl at washers and head of the
bolts. The lag bolts should go through the collar
and into the hopper body.
7. Attach the lids to the collar by sliding them into
place and inserting the large washers onto the lid
hinge pins. Insert the D-ring pins into the holes on
the lid hinge pins.
Lag Bolt
Lock Washer
Flat Washer
  • Page 1 1
  • Page 2 2

Western Poly Hopper Spreader Collar (2.5 Cu. Yd.) Serial #0905-Higher #78006/78007/78008 Installation guide

Western
Brand
Western
Model
Poly Hopper Spreader Collar (2.5 Cu. Yd.) Serial #0905-Higher #78006/78007/78008
Category
Car kits
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents