Dedicated Micros ©2010
3
SD Range
View Control
Red Full Show currently selected camera full screen.
Green Quad Displays four images on-screen, putting the
currently selected camera in the top left segment
of the four. All displayed cameras will increment
by four if pressed again i.e. if cam 1 is shown top
left, the views will increment to cam 5 top left,
cam6 top right etc.
Note: When a camera button is pressed to select a new camera, the new selection will be
displayed in the top left hand corner of the display. The next three connected cameras will
be displayed in the following three positions.
Yellow Multi Displays multiple camera images on-screen,
putting the currently selected camera in the
top left segment, followed by the next available
camera(s). If pressed again, it will increment
all cameras by the number of images shown in
the multi-display i.e. if nine cameras are shown;
cam 1 displayed top left, cam 2 adjacent etc.
the views will increment to cam 10 top left,
cam 11 adjacent etc. Selecting any displayed
camera will place that camera’s images rst in
the multi-display, with other cameras following in
sequential order. This increment display feature
can be turned Off via the ’Camera selection
switches to full screen’ option. (Conguration
menus:Display Settings ->Display). When
selected, this option will result in a camera
selected from multi view being displayed full
screen.The number of cameras displayed will
depend on that selected in the ‘Default Multi
Display’ option (Conguration menus:Display
Settings->Viewer Defaults)