Document: 00-02-1689 rev. A
C R R e a d e r Q u i c k S t a r t G u i d e
System Requirements
Operating System: Microsoft Windows 7 or Windows 8 (32 bit or 64 bit)
CPU: Pentium 4 / 1.4 GHz
Memory: 2GB or more (RAM)
USB: USB 2.0 High Speed
STEP ONE – Software Installation
1. Insert flash drive into an
available USB port
4. In the “Devices to Install”
window, ensure ClearVision
CR or VetPro CR is checked
and select Install
2. Navigate to the root of the
flash drive and run
setup.exe
5. When the Device Suite
installation is complete, a
green check mark will appear
3. Select “Install Progeny
Device Suite”. This will start
the installation process.
Follow the instructions on
the screen
6. Select “Install Progeny
Imaging”. This will start the
installation process. Follow
the instructions on the
screen. When the installation
is complete, a green check
mark will appear