Midmark ClearVision® Digital CR System Installation guide

Type
Installation guide

This manual is also suitable for

Document: 00-02-1689 rev. A
C R R e a d e r Q u i c k S t a r t G u i d e
System Requirements
Operating System: Microsoft Windows 7 or Windows 8 (32 bit or 64 bit)
CPU: Pentium 4 / 1.4 GHz
Memory: 2GB or more (RAM)
USB: USB 2.0 High Speed
STEP ONE Software Installation
1. Insert flash drive into an
available USB port
4. In the “Devices to Install”
window, ensure ClearVision
CR or VetPro CR is checked
and select Install
OR
2. Navigate to the root of the
flash drive and run
setup.exe
5. When the Device Suite
installation is complete, a
green check mark will appear
3. Select “Install Progeny
Device Suite”. This will start
the installation process.
Follow the instructions on
the screen
6. Select “Install Progeny
Imaging”. This will start the
installation process. Follow
the instructions on the
screen. When the installation
is complete, a green check
mark will appear
page one
Document: 00-02-1689 rev. A
C R R e a d e r Q u i c k S t a r t G u i d e
1. Unpack the CR unit and
attach the supplied USB
cable to it. Connect the
other end of the USB cable
to an available USB port on
your workstation
4. If prompted to login, enter
the user name
“administrator” and no
password. Select “Login”
2. Connect the supplied Power
supply to the CR unit and
power the unit on utilizing
the power switch located on
the back
5. At the top menu bar select
the drop down next to the
Red orb, select “ClearVision
CR” or “VetPro CR”
OR
3. Launch Progeny Imaging by
double clicking on the
application icon located on
your desktop
6. The orb will turn green
indicating that the unit has
successfully connected and
is ready for use
OR
page two
  • Page 1 1
  • Page 2 2

Midmark ClearVision® Digital CR System Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI