DeckoRail 117659 Installation guide

Recessed Lighting Kit Installation Instructions

Low voltage 8-piece LED light kit

IMPORTANT SAFETY INFORMATION PERTAINING TO

RISK OF FIRE OR INJURY TO PERSON.

• Donotinstallwithin10feet(3m)ofapool,spaorfountain.

• Donotlookdirectlyintothelight.

• Forusewith12-volt,low-voltageoutdoorlandscapelighting

 systemonly.

• Therearenoserviceablepartsinsidethepowersupplyunit.

 Donotdisassemble.

• PlugthepowersupplyunitdirectlyintoaGFCIreceptacle

thatismarked"wetlocation."

• Thetransformercansupportamaximumof24individual 

 lights.Werecommendusingamaximumof16lightsforbest

 performance.

Please note: The light system must be installed in accordance

with all local codes and ordinances. If you are experiencing

problems, contact a qualiﬁed electrician.

Step 1: Find a location for the transformer and photo sensor.

• Outdooruse,weather-resistant.

• Donotinstallthephotosensorbehindshrubs.

Thiswillaffectthephotosensor.

• Thephotosensorwillnotoperateproperlyif

installedtooclosetoalightsource.

Step 2: Mount the photo sensor.

Mountthephotosensorwiththeincluded

screwonawallwithinonefoot(30cm)of

theelectricaloutletwherethetransformer

willbeconnected(g.1).

*Alternatephotosensorinstallation:Ifthereisnoareawithin1foot

(30.5cm)ofthetransformertoinstallthephotosensor,itispossibleto

installtheextensionwiredirectlytothetransformerandtoinstallthe

photosensorbetweentheextensionwireandtherstlight.

Step 3: Position lights and run wire.

• Thewireshouldrunfromthephotosensortoeachlight,

withoutbeingcut.Donotrunthewirewithin10feet(3m)

ofapool,spaorfountain.

• Loosewireshouldbetiedupandkeptclearofwalking

pathsandawayfromchildrenoranimals.

• Connecttheextensionwireandalllightxturesend-to-end,

makingonelongwireconnection.Thisisthedistance

availablewhenpositioningyourlights.

Please note: Additional light and wire add-ons are available

in packs of two. Additional extension wire is available in 16.4’

length. These add-ons are compatible with and follow the same

installation steps as the lights and wire in the original kit.

• Mostcommonlightplacementsareonsteprisersto

illuminatestairs,oratonthedecksurfacetodelineate

extremitiesandilluminaterailingsorwalls.

• Positionthelightxtures,makingsurethattheextension

wirewillreachthephotosensor.Oncetheyareproperly

positioned,drilloutholesusingtheincluded1"drillbit.

Important note: Please make sure that you

have properly calculated your distances

and are conﬁdent of the positioning

of the lights before drilling holes.

extension wire

transformer

LED deck light

photo sensor

drill bit

g.3

g.1

g.2

One Recessed Lighting Kit contains:

• Eight (8) LED deck lights

• One (1) transformer

• One (1) extension wire

• One (1) photo sensor

• One (1) drill bit

transformer

photo sensor

connector

light ﬁxture

extension

wire

Illustration of ﬁxture is for example only.

For more information, visit our Web site at: http://www.ufpi.com

Continued on reverse

• Disconnectthelightsfromeachotherandinserteachxture

intoitscorrespondingholebyfeedingthetwo(2)wiresrst

thenpressingthexturermlyintotheholesothatitts

tightlyagainstthesurface.Therearetwobulbsineachlight.

Makesurethebulbsareconsistentlyorientedhorizontallyor

vertically.Repeatthisstepforalleight(8)lights.

• Connectthemaleendoftheextensionwiretothe"OUT"

connectionofthephotosensorandthefemaleendtothe

rstxture.

• Connectthefemaleendoftheextensionwiretothe

rstlightxtureandeachxturetothenext.

Step 4: Connect the photo sensor and the transformer.

• Connectthephotosensortothetransformer.

• Plugthetransformerintotheelectricalreceptacle.

How to test the system

• Totestthelightsduringdaytime,coverthephoto

sensorwithblacktape.

• Thiscomponentreactstolightconditions.Itautomatically

turnsONthelightxturesatduskandturnsthemOFFat

dawn.Itshouldnotbeexposedtoanyarticiallightsources.

Trouble shooting

• Mostproblemsliewithinthexture'sconnectionorLEDs.

• Checktheconnectionandmakesurethemaleandfemale

connectorsarepressingrmlytogether,andsecurewith

thescrewnut.

• Tocheckalightxture,exchangeitwithanotherxture

thatisworking.

Maintenance

• Toclean,wipewithasoft,dampcloth.

• Replacementpartsmaybeorderedbyusingthexture

modelnumberandthepart'sname.

Thediagramsandinstructionsinthisbrochureareforillustrationpurposesonlyandarenotmeanttoreplacealicensedprofessional.

Anyconstructionoruseoftheproductmustbeinaccordancewithalllocalzoningand/orbuildingcodes.Theconsumerassumesall

risksandliabilityassociatedwiththeconstructionoruseofthisproduct.Theconsumerorcontractorshouldtakeallnecessarystepsto

ensurethesafetyofeveryoneinvolvedintheproject,including,butnotlimitedto,wearingtheappropriatesafetyequipment.SELLER

MAKESNOWARRANTYFORTHISPRODUCT,EITHEREXPRESSORIMPLIED.SELLEREXPRESSLY DISCLAIMS ANY AND ALL

LIABILITYFORDAMAGESARISINGOUTOFTHEUSEOROWNERSHIPOFTHEPRODUCT,INCLUDINGDISCLAIMINGINCIDENTAL

ANDCONSEQUENTIALDAMAGES,UNLESSOTHERWISEREQUIREDBYSTATELAW.

877.463.8379

933USRoute202,Greene,ME04236www.ufpi.com5449_3/12

Recessed Lighting Kit Installation Instructions, continued

OUTDOOR

TRANSFORMER

TRANSFORMATEUR

POUR L’EXTÉRIEUR

ADAPTADOR DE PODER

PARA EXTERIORES

E323535

DeckoRail 117659 Installation guide

Other documents