AlsowhiletheMeatisashingyoucanraiseandlowertheUSDAdonenesslevel(SETTemperature)
bypressingHItoraiseitorLOtolowerit.TheFOODtemperaturerangeis32ºF-572ºF.
PressingSETbuttonatanypointwillsetthecurrentsettings.Notpressinganybuttonsforafew
seconds will also do the same.
Barbecue selection
IfyoupressedSETinBARBECUEmodethentheHISETtemperaturewillashinthecorresponding
probeeld.PressHItoraiseitorLOtolowerit.TherangefortheHISETtemperatureis140ºF–572
ºF. Default temperature from the factory is 250 ºF.
PressSETtosettheHISETtemperature.TheLOSETtemperaturewillash.PressHItoraiseitorLO
tolowerit.TherangefortheLOSETtemperatureis32ºF–554ºF.Defaulttemperaturefromthe
factory is 200 ºF.
PressingSETbuttonatanypointwillsetthecurrentsettings.Notpressinganybuttonsforafew
seconds will also do the same.
Note: The unit will not allow you to set the maximum BARBECUE temperature below the
minimum BARBECUE temperature. It will automatically change the LO temp to 2 degrees below
the HI.
Activating the temperature alarm
YoucanpresstheALERT,ºC/ºFbuttontoactivatethetemperaturealarmforBothprobe1and2.
The alarm icons will appear above the actual temperature.
Thereceiverwillbeepwiththealarmiconandprobetemperatureashingif:
a) TheactualFOODtemperaturehasexceededyoursetmaximumFOODtemperature.
(ThealertBeeps3timeseverysecondifthetemperatureiswithin6
o
C or 10 F of the set
temperatureandbeeps4timeseverysecondoncethesettemperatureisreached)
b) TheactualBARBECUEtemperaturehasexceededyoursetmaximumBARBECUEtemperature.
(Beepstwiceineverysecond)
c) TheactualBARBECUEtemperaturehasfallenbelowyoursetminimumBARBECUE
temperature.
(Beepsonceineverysecond)
Note if you press the ALERT, ºC /ºF button and the actual probe temperature is above the FOOD
set temperature or out of range of your BARBECUE set temperature then the Alert icon and the
actual probe temperature will ash immediately indicating the issue.
Note: The minimum BARBECUE temperature alarm will not be activated until the actual
BARBECUE temperature goes above the set minimum temperature.
For example: You set the minimum BARBECUE temperature as 220 ºF and press the ALERT, ºC /
ºF, to activate the alarm. The unit will NOT beep or ash even if the actual BARBECUE
temperature is below 220 ºF. It assumes that your BARBECUE is not up to temperature. Only when
the actual BARBECUE temperature goes over 220 ºF, then falls below 220 ºF, can the alarm be
activated, the unit will beep and ash.
Note: The unit will retain your Barbecue & Food alert temperature settings even after the unit is
turned off.
Procedure for typical use in an outdoor barbecue
Monitor 1 FOOD and 1 BARBECUE
ThefollowingtypicalexampleswillgothroughthestepstohavetheET-733REDICHEKBARBECUE
alarmyouifapieceofmeatBEEFiscookedto173ºFandifyourbarbecuetemperaturefalls
below 225 ºF or goes above 275 ºF.
Set up barbecue
1. Follow the registration procedure.
2. PlaceBEEFonthebarbecuegrillrack.
3. Insertprobe1intothecenterofthickestportionofthemeat.Avoidtouchingboneorheavy
fat areas.
3. Clipprobe2togrillrackofbarbecuegrillrack.
4. Positiontheprobesensorwiressotheywillnotcomeintocontactwithamesandexitthe
barbecuewithoutbeingpinched/crushedbythecover.
5. Stand/hangthetransmitterawayfromheatsourceofbarbecue.DONOTputtransmitteron
closed cover or under the cover. The transmitter is water proof for use in rain.
Probe 1: FOOD, BEEF, WELL DONE, SET TEMPERATURE 173 ° F
1. PressandholdSETbuttonfor2seconds.
2. PressHIorLObuttontoswitchashingprobeinupperlefthandcornerto(1).
3. QuicklypressSET.
4. PressMODEbuttonsoFOODisdisplayed.
5. QuicklypressSET.
6. PressMEATbuttonuntilBEEFisdisplayed.
7. QuicklyPressTASTEbuttonuntilW.DONEisdisplayed.
8. QuicklyPressHIbuttonuntil173isdisplayedasHISET.
9. Press set.
Probe 2: BARBECUE, 225 °F LO SET, 275 °F HI SET
1. PressandholdSETbuttonfor2seconds.
2. PressHIorLObuttontoswitchashingprobeinupperlefthandcornerto(2).
3. QuicklypressSET.
4. PressMODEbuttonsoBARBECUEisdisplayed.
5. QuicklypressSET.
6. PressandholdHIorLObuttonuntil275isdisplayedasHISET.
7. QuicklypressSET.
8. PressandholdHIorLObuttonuntil225isdisplayedasLOSET.
9. Press set.
Helpful Hints
Ifthereceiverand/orthetransmitterdisplayLLLorHHHinsteadoftheprobetemperature,
waitforprobetoreachroomtemperature.IfLLLorHHHisstilldisplayedoryougetafalse
temperature,squeezetheprobejacksharderintothetransmitterandtwistthembackand
forthsotheymakegoodcontact.Iftheproblemstillpersistsitislikelytheinternalprobewirehas
shorted out either through moisture or heat damage.
Do not immerse the probe in water while cleaning.
Donotallowtheprobeorprobewiretocomeintocontactwithames.
Withinthewarrantyperiod,returndefectiveprobetoaddressbelowalongwithreturnaddress
and we will send you a replacement probe at no charge.
If the temperature displayed seems to read too high or the temperature seems to increase too
quickly,checktomakesuretheprobetipisnotpokingthroughthefoodtooutside.Reposition
theprobetipinthecenterofthethickestpartoffood.Avoidtouchingboneorheavyfatareas.
Cautions:
1) Alwayswearaheatresistantglovetotouchthestainlesssteelprobesensorsorwiresduringor
justaftercooking.Donottouchwithbarehands.
2) Keepthestainlesssteelprobesensorsandwiresawayfromchildren.
3) Cleanthestainlesssteelprobesanddrythoroughlyaftereachandeveryuse.
4) Donotusethereceiverintherain.ItisNOTrainproof.Thetransmitterisrainproofbutnot
water tight. Do not immerse in water.
5) Donotexposetheplugsofthestainlesssteelprobesorthepluginholesofthetransmitterto
water or any liquid. This will result in a bad connecting and faulty readings.
6) Donotexposethereceiverortransmittertodirectheatorsurface.
7) Donotusestainlesssteelprobesinmicrowaveoven.
8) TheBarbecueThermometerregisterstemperaturesaslowas32ºF(0ºC)andashighas572ºF
(300ºC).LLLwillbedisplayedbelow32ºFandHHHwillbedisplayedabove572ºF.Donotuse
the stainless probe sensor above 572 ºF. Doing so will deteriorate the wire.
9) NotIntendedforUsebyPersonsages12andUnder.
Cleaning
1) Alwayswearaheatresistantglovetotouchthestainlesssteelprobesensorsorwiresduringor
justaftercooking.Donottouchwithbarehands.
2) Keepthestainlesssteelprobesensorsandwiresawayfromchildren.
3) Washthemetalprobetipswithhotsoapywateranddrythoroughly.Donotimmersethe
probe in water while cleaning.
4) Wipethetransmitterandreceiverwithdampcloth.Donotimmerseeitherinwater.
Information to user
Warning: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the users’ authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interferencebyoneormoreofthefollowingmeasures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Thisdevicecomplieswithpart15oftheFCCRules.Operationissubjecttothefollowing
twoconditions:(1)thisdevicemaynotcauseharmfulinterference,and(2)thisdevice
must accept any interference received, including interference that may cause undesired
operation.
LIMITED NINETY DAY WARRANTY
MaverickIndustriesInc.warrantstheET-733REDICHEKBARBECUEThermometertobefreeof
defectsinparts,materialsandworkmanshipforaperiodof90days,fromdateofpurchase.
Shouldanyrepairsorservicingunderthiswarrantyberequired,contactMaverickCustomer
ServicebyemailormailforinstructionsonhowtopackandshiptheET-733REDICHEKBARBECUE
ThermometertoMaverick’sNationalServiceCenterlocatedasfollows:
Maverick Customer Service
94 Mayeld Ave.
Edison NJ 08837
Telephone: (732) 417-9666
DonotsendanypartsorproducttoMaverickwithoutobtainingaReturnAuthorizationNumber
and instructions.
ThiswarrantyisVOIDifinstructionsforusearenotfollowed;foraccidentaldamage;for
commercialuse;fordamageincurredwhileintransit;oriftheET-733REDICHEKBARBECUE
Thermometer has been tampered with.
Thiswarrantygivesyouspeciclegalrightsandyoumayalsohaveotherrightswhichvaryfrom
state to state.
Replacement Probes
Topurchase,outofwarranty,stainlesssteelreplacementprobespleasemailusachecktothe
addressbelowandspecifyprobetype:
ET-7336ftHybridProbe$20.00/ea
Setof6ftHybridprobes$33.00/set
Allpricesincludeshipping&handling.NJresidentsadd7%salestax.
Attn Customer Service
Maverick Industries, Inc.