2. TIRAMISUBEST
  3. W550XY58044
W550XY58044

TIRAMISUBEST W550XY58044 User manual

  • Hello, I have analyzed the user manual for the Nest Swing. This document provides instructions on assembling the swing and stand, including steps for attaching various components like swing tubes, cords and the frame. I'm ready to answer any questions you have about setting up and using the Nest Swing.
  • What is the maximum user weight for the nest swing?
    What is the diameter of the nest swing?
    What is the assembled height of the stand?
Nest Swing With Stand
Stand Assembled Height:79
Nest Swing Diameter:43
Maximum User Weight:150KG(330LB)
Light strip set
1.Lay the nest swing (1) on the floor and open the tabs with the Velcro straps.
2.Slide swing tubes (2) into the pockets of nest swing (1) as shown below.
4.Place the two swing cords (3) with the suspensions made of plastic in the correct sequence
next to the nest swing (1).Please make sure that the swing cords (3) are not twisted.
5.Slide the plastic suspension of the swing cords (3) from above through the opening of the tab
with the Velcro straps.Then use side “II” (see marking) to attach the suspension to the thicker tube
6.Now connect the swing tubes (2) to each other,while pressing down the spring button on the
thinner end of the tube.The inter-locking is achieved through the latching and clicking of the
spring button.Now,close the tab with the Velcro straps.
Now,the nest swing seat is assembled as the
photo shows.
7.Slide the light strip in the light strip set (18)
into the pockets of nest swing (1) .Control the
light strip with the remote controller in the light
strip set (18) .
18
8.Put the thicker end of bottom frame tube
(4) to plastic protective sleeve (16) and
please make sure they are tightenly
connected.Connect upper frame tube (6)
to middle frame tube (5),and the connection
is achieved with M8 Bolt (8) ,M8 Spring
washer (10),and M8 washer (9).Tighten the
Connection with L shaped wrench (B).Repeat
the process on the connection between upper
frame tube (6) and middle frame tube (5).
9.Connect cruciform tube (7) to the 4 pcs
upper frame tubes (6),using M8 Bolt (8),
M8 Spring washer (10),and M8 washer
(9).Tighten the Connection with L shaped
wrench (B).
16
10.Attach carabiner (14) and M10 ring bolt
(13) to cruciform tube (7) with M10 was-
her (12),M10 spring washer (19) and M10
nut (11). Tighten them with M10 wrench
(C).
11.Rotate the lock of carabiner (14) until
it is open.Hang the nest Swing on the
stand by putting the ring of swing cords
(3) in the carabiner (14).Make sure you
lock the carabiner (14).
13.Put Ceiling (17) on the top of the stand.
17
12.Remove part a and b from rope (15).
Attach the bolt of rope (15) to bottom
frame tube (4).Then Tighten connection
with part a,b and wrench (A).
14.Congratulations! All Steps are finished.
please check again whether All connections
are tightened or not.If all tightened well,You
Can enjoy the fun now!
/