Dent 1000A Clamp on CT to A Load Operating instructions

Brand
Dent
Model
1000A Clamp on CT to A Load
Type
Operating instructions
DENT INSTRUMENTS, INC. | 925 SW EMKAY DRIVE | BEND, OREGON 97702
Phone 541.388.4774 | fax 541.385.9333 | www.DENTinstruments.com
STEP-BY-STEP GUIDE
TO CONNECTING 1000A
CLAMP ON CT TO A LOAD
rev073018
ALL WORK SHOULD BE
PERFORMED BY A QUALIFIED
ELECTRICIAN USING PROPER
SAFETY EQUIPMENT
Equipment is protected throughout by
double insulation.
1. Open the CT by holding squeezing
the lever on the side.
2. Connect CT around the load
conductor to be measured. Make
sure the CT is oriented in the proper
direction according to the label on
the CT.
3. Allow the CT to close. The conductor
should be in the inside of the CT
window (See Photo 2.)
4. Connect the red wire on the CT to
the positive terminal on the
measuring device. (See Photo 3.)
5. Connect the black wire on the CT to
the negative terminal on the
measuring device. (See Photo 3.)
6. You are now ready to begin your
monitoring session.
Photo 1:
Open CT.
Photo 2: Install CT
Around Conductor.
Photo 3: Connect Red
Wire to Positive
Terminal. Connect Black
Wire to Negative
Terminal.
Positive
Negative
  • Page 1 1

Dent 1000A Clamp on CT to A Load Operating instructions

Brand
Dent
Model
1000A Clamp on CT to A Load
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents