Recommended Installation by a Professional Plumbing Contractor
Locate the desired position of slide bar on finished wall. See Fig. 1.
Mark wall and drill 5/16” hole for WALL ANCHORS (1) to dimension
shown in Figure 1.
Place SLIDE BAR (2) into END POST (3). Note: Large diameter hole in
SLIDE BAR (2) must face out as shown in Figure 2.
Place POST (3) onto ESCUTCHEON (4), insert SCREW (5) & securely
tighten into ANCHOR (1) as shown in Figure 2.
Press END CAP (6) into end of POST (3).
Slide and lock HOLDER ASSEMBLY (7) onto SLIDE BAR (2) and repeat the above steps to the
other end of SLIDE BAR (2) as shown in Figure 3.
INSTALLATION INSTRUCTIONS
SLIDE BAR ASSEMBLY
MODEL NO. 292
Figure 2
6
5
3
2
4
1
Figure 3
2
7
6
1
4
3
5
(949) 417-5207
NWP-292 Santa Ana, Ca. 92705 10/10/2011
www.brasstech.com
23”
Figure 1
1
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Fitness Reality 2852 Owner's manual
-
Grizzly G4015Z User manual
-
ITT Goulds Pumps ICO Operating instructions
-
Grizzly Industrial G4015Z User manual
-
TRIANGLE TUBE Brazed Plate Heat Exchanger User manual
-
-
Miller HK270136 Owner's manual
-
Quadra-Fire HUDBAY-INS Owner's manual
-
-
KidKraft Copper Ridge Wooden Playset Assembly Instruction
