Feiss WB1867 Installation guide

Type
Installation guide
1
Installation Instructions for
Install the inner diffuser by carefully sliding it down the channel.
Install the endcaps to the outer diffuser and secure from the inside using the thumb nuts and curved washers.
CAUTION: Do not over tighten the outer glass.
Install the outer diffuser to the ends of the channel using the flat-headed screws.
Secure the mounting plate to the junction box.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the set screw using an Allen key.
1
2
3
1A
4
5
Cutler Wall (LED)
1.0
WB1870-WB1871-LED
WB1870, WB1871
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
For a complete list of dimmers, visit out website at www.Feiss.com
JUNCTION BOX
MOUNTING
PLATE
6
7
ALLEN KEY
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
8
6
7
SET SCREW
FIXTURE
FLAT-HEADED SCREW
2
OUTER
DIFFUSER
ENDCAP
CHANNEL
INNER DIFFUSER
THUMB NUT AND
CURVED WASHER
1
3
8
2
3
SAVETHESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.Feiss.com
© 2018 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Feiss WB1867 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI