2. Legrand
  3. 36468501
36468501

Legrand 36468501, Mini Coax Stripper, IS-0248, Mini-Coax Stripper/Replacement Blades - 364685-01/364687-01 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Legrand 36468501 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IS-0248 Rev. O Page 1 of 1
Installation/Instruction Sheet
Mini Coax Stripper /
Replacement Blades
IS-0248 Rev O
OnQ Technologies, Inc.
P.O. Box 60907
Harrisburg, PA 17106-0907
800-321-2343
www.onqtech.com
TO STRIP CABLE:
1. While holding the tool, depress the lever. Insert the cable across the cartridge in the direction of the arrow until
it hits the stop.
2. Let go of the lever. Supporting the cable with one hand, insert forefinger of the other hand into the large hole on
the opposite end of the tool. Spin the tool approximately three revolutions. You will hear the braid cutting and
feel the tool spin freely. At this point you can reverse the spin. Depending on the cable you are using, the
number of reverse spins will vary.
3. Grasp tool firmly around the cartridge without depressing the lever and pull the tool away from the cable.
NOTE: The notched blade in the cartridge eliminates the risk of scoring the center conductor and cuts through
the jacket, braid, foil and dielectric leaving the center conductor exposed. The Shallow blade cuts through only
the jacket of the cables.
TIP: After stripping the cable, depress the lever. A tab will move up between the blades and remove any remaining
debris.
REPLACING CARTRIDGES:
The purpose of this tool is to provide consistent quality, while saving time. For this tool to perform correctly, the
cartridge must be replaced when the blades are dull. Depending on the cable you are using, the number of cuts per blade
cartridge varies. For best performance the blade should be kept free of debris. If you see that the cut is not as clean, the
braid is not cut evenly, or the tool takes more revolutions to perform the cut – REPLACE THE CARTRIDGE
IMMEDIATELY.
HOW TO REPLACE THE CARTRIDGE:
While holding the tool, depress the lever and grasp the cartridge on both sides. Then pull cartridge toward the lever to
remove. Reverse this process for cartridge installation, snapping the cartridge in place. Move fingers away from cartridge
and let go of lever.
TO BE USED WITH THE FOLLOWING OnQ PART NUMBERS:
364682-01 - AnyPort Express Mini Coax “F” Plug
364683-01 - AnyPort Express Mini Coax RCA Plug
364684-01 - AnyPort Express Mini Coax BNC Plug
364710-01 - AnyPort Express Universal Crimp Tool
364686-xx - Mini Coax Cable (250 ft.)
(xx indicates color: 01 = red, 02 = yellow, 03 = blue, 04 = black, 05 = white, 06 = green)
/