Assembly & Setup
STAR TRAC FITNESS 1 of 5 637-1503 Rev: A
Back Pad Brace Support Kit (731-5615-KT)
STS Impact Seated Leg Press (PR-S1305 & LL-1305)
Parts Required:
• Back Pad Brace Support Kit (PN: 731-5615-KT)
Tools Required:
• SAE Hex Key Wrench Set or Specific Keys
o 3/16 Hex Key
• SAE Socket Set & Wrench or Specific Socket
o 9/16 SAE Socket
Instructions:
1. From the rear of the machine; remove the four button head cap screws (Fig. 1) using a 3/16 SAE hex key to take
off the back pad.
Fig. 1
Assembly & Setup
STAR TRAC FITNESS 2 of 5 637-1503 Rev: A
2. Locate the large support plate and insert all supplied button head cap screws into the square cut outs (Fig. 2).
Fig. 2
3. Lay the support plate with bolts over the vertical back pad strut (Fig. 3).
Fig. 3
Assembly & Setup
STAR TRAC FITNESS 3 of 5 637-1503 Rev: A
4. From the rear of the unit, mount one the support braces over the upper set of button head cap screws (Fig 4).
Fig. 4
5. Mount the required hardware (Fig. 5) over the support brace in the following order: spacer, washer, & nut (Fig. 6).
Leaving the hardware loose at the moment.
Fig. 5
Fig. 6
Assembly & Setup
STAR TRAC FITNESS 4 of 5 637-1503 Rev: A
6. Now maneuver the second support brace thru the highlighted opening (Fig. 7) and mount the required hardware.
Fig. 7
7. Place the back pad over the support strut and reinstall the original four button head cap screws using a 3/16 hex
key. These bolts can be tightened completely and will provide proper alignment of the brace kit (Fig 8.).
Fig. 8
Assembly & Setup
STAR TRAC FITNESS 5 of 5 637-1503 Rev: A
8. At this point, we can go back and torque all four nuts used in the kit with a 9/16 socket. Torque all nuts until one
thread of the bolt extrudes past the nylon patch of the nut (Fig 9).
Fig. 9
9. When the whole kit is installed; all braces will blend in with the rest of the components (Fig. 10).
Fig. 10
/
