RXF Front Fork kit for Suzuki RM-Z 250/450
FGSU 1496
Mounting Instructions
Note!1
Please note that the images in this folder are a general
representation of the product and may differ slightly
from your product.
Note!1
Please note that during storage and transportation,
especially at high ambient temperature, some of the oil
and grease used for assembling may leak and stain the
packaging. This is in no way detrimental to the product,
wipe off the excessive oil/grease with a cloth.
Note!1
Before installing this product, check the contents of
the kit. If anything is missing, please contact an Öhlins
dealer.
Warning!⚠
Before installing this product, read the Öhlins Owner’s
Manual. The shock absorber/front fork/steering damper
is an important part of your vehicle and will affect
the stability.
Kit Contents
Description Part No Pcs
Front Fork RXF 48 kit FGSU1496 1
TTX Cartridge sticker 00191-40 2
Sticker Öhlins 00192-01 2
Owner’s manual 07295-31 1
2
MOUNTING INSTRUCTIONS
Warning!⚠
It is advisable to have an Öhlins dealer install the shock
absorber/front fork/steering damper.
Warning!⚠
If working on a raised vehicle, ensure it is securely
supported so that it will not tip.
Note!1
Before mounting this product clean the vehicle
thoroughly.
Note!1
When working on this product, always see the Vehicle
Service Manual for vehicle specic procedures and
important data.
1
To install, see the vehicle service manual
and the mounting instructions in the Owner’s
manual.
Tightening torque
Upper triple clamp M8 20 Nm
Lower triple clamp M8 15 Nm
Brake caliper M8 25 Nm
Fork protectors M6 7 Nm
Front wheel axle 50 Nm
Front axle clamp M8 15 Nm
3
MOUNTING INSTRUCTIONS
ADJUSTMENTS
Warning!⚠
Before riding, always make sure that the basic settings
made by Öhlins are according to recommended Set-
up Data. Read about adjustments and setting up in
the Öhlins Owner’s Manual before you make any
adjustments. Contact an Öhlins dealer if you have any
questions about setting up.
Öhlins Racing AB
Box 722
S-194 27 Upplands Väsby, Sweden
Phone +46 8 590 025 00
fax +46 8 590 025 80
© Öhlins Racing AB. All rights
reserved. Any reprinting or
unauthorized use without the written
permission of Öhlins Racing AB
is prohibited.
Öhlins products are subject to
continuous improvement and
development, therefore, although
these instructions include the most
up-to-date information available at
the time of printing, minor updates
may occur.
To nd the latest information
contact an Öhlins distributor.
Please contact Öhlins if you have
any questions regarding the
contents in this document.
SETUP DATA
SPRING GUIDE
Part no. MI_FGSU1496_0
Issued 2013-09-23
Front fork length 943 mm
Front fork stroke 306 mm
Rebound damping 15 clicks
Compression damping 15 clicks
Fluid volume (each leg) 0,370 litre
Volume range (each leg) 0,300-
0,400 litre
Öhlins Front Fork uid 01309-01
Spring
Installed spring 08765-49
Spring rate 4,9 N/mm
Spring free length 467±3 mm
Optional springs 08765-43,-45,-47,-51
Spring preload 4 mm
Spring preload range 0-8 mm
Adjust by adding /removing washer 15443-02
*Rider’s weight: Rider wearing proper riding gear.
Make sure you know your total weight with riding gear.
Riding gear weighs between 5 and 15 kg.
FGSU 1496
kg/pound* 250cc 450cc
60/132 44-46 45-47
65/143 45-47 46-48
70/154 45-47 46-48
75/165 46-48 47-49
80/176 46-48 47-49
85/187 47-49 48-50
90/198 47-49 48-50
95/209 48-50 48-50
100/220 48-50 49-51
105/231 48-50 49-51
110/242 49-51 50-51
115/253 49-51 51
120/264 51 52
125/275 51 54
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ohlins FGKT1496 Mounting Instruction
-
-
-
-
-
-
-
-
-