air MAX 900 g L246 Operating instructions

6314056 20190829

Bison International B.V. - P.O. Box 160 - NL 4460 AD Goes 1

maximumagainstmoisture.com

Our advice is based on extensive research and practical experience. However, in view of the large variety of materials and the conditions under which our products are applied, we assume no responsibility for the results

obtained and/or any damage caused by the use of the product. Nevertheless, our Service Department is always at your disposal for any advice needed.

Practical refill bag for refilling air Max® Moisture

absorber

air Max® Moisture absorber

6314056  AIR MAX® MOISTURE ABSORBER ORIGINAL 900 G L246

Directions for use:

INSTRUCTIONS FOR USE – REPLENISHING WITH REFILL BAG OR MOISTURE

MAGNET

1. Cut the packaging open carefully and take out the rell Bag or Moisture

Magnet.

2. Remove the lid from the device and place the rell Bag or Tab in the container.

Attention: make sure the bag does not stick outside the device.

3. Replace the lid and Moisture Absorber is ready for use.

4. Place the device on a solid and stable surface.

5. Moisture Absorber is easy to empty once the salt has completely dissolved

(dispose the empty rell bag). See separate instructions for emptying the

device.

6. Replenish with a new rell.

INSTRUCTIONS FOR USE – REPLENISHING WITH CRYSTALS

1. Cut the packaging open carefully.

2. Remove the lid from the device and evenly distribute the crystals in the

container untill the ‘MAX’ indicator.

3. Replace the lid and Moisture Absorber is ready for use.

4. Place the device on a solid and stable surface.

5. Moisture Absorber is easy to empty once the salt has completely dissolved.

See separate instructions for emptying the device.

6. Replenish with a new rell.

EMPTYING THE DEVICE

Open the device indoors over the toilet and empty the reservoir. Rinse the toilet

well with water.

Important: Spilled liquid can cause staining. In case of stains wash immediately

with plenty of water

and dab thoroughly dry. Repeat if necessary. Avoid contact with leather and

metal: these

materials are at risk of damage.

Stains/residue: Spilt uid can cause surface marks. If uid is spilt, it should be

cleaned immediately using large volumes of water and dabbed repeatedly until

dry. Avoid contact with leather, wood, stone and metal, as these materials can

be aected negatively.

Advice: Always place the Air Max® Moisture Absorber Original on a at and

stable surface.

Points of attention: At lower temperatures the Moisture Absorber works more

slowly and clumping can occur. Increasing the temperature will speed up the

working again. Avoid spilling of rell or collected moisture: leather, wood, stone

and metal can be aected negatively.

TECHNICAL SPECIFICATIONS

Chemical base: Calcium chloride

Colour: White

Specications: Water absorption: about 1 gram of water per gram of salt.

PRODUCT DESCRIPTION

Practical rell bag for relling Air Max® Moisture Absorber

FIELD OF APPLICATION

Practical rell bag for relling Air Max® Moisture Absorber

PROPERTIES

· Protects your valuables against moisture

· Ready to use rell bag

· Uses no energy

· Refreshes the air

· Works clean

· Works silently

APPLICATION

Coverage: 900g works for approximately 3 months in a room up to

approximately 90 m³ and absorbs with a lling of 900g approximately 1 litre of

water, depending on the temperature, humidity and size of the room.

6314056 20190829

Bison International B.V. - P.O. Box 160 - NL 4460 AD Goes 2