Workbench Series
WB362460-60” WORKBENCH
WB362472-72” WORKBENCH
WB362490-90” WORKBENCH
Warning: Excessive weight hazard!
High risk of injury if installed incorrectly: Follow instructions carefully and
routinely inspect your system to ensure all components are fastened
securely. For assistance, call 901-872-0188, option 0 or e-mail
Rated weight Capacity
Evenly Distributed
Weight Capacity
(lbs)
Tray Weight Capacity
(lbs.)
60” Workbench
2000lbs
40
72” Workbench
2000lbs
40
90” Workbench
2000lbs
40
Warning:
Mechanical Max Load: 2000lbs;
Eletronical Limitation Max: 15A
Parts List:
** Bottom Supporting Frame: 2pcs; ** Upper Supporting Frame: 2pcs
**Side support beam : 2pcs; ** Long support beam: 1pc
**Tool Tray+Tool Tray Driver +Tablet Stand ** Wood Top
Parts and hardware supplied
(1) Hardware list:
Parts
60”
72”
90”
Workbench
Workbench
Workbench
Side support Beam
2
2
2
Long Support Beam
1
1
1
Upper Supporting Frame(A)
2
2
2
Lower Supporting Frame(B)
2
2
2
Tool Tray
1
1
1
Tool Tray Dividers
4
6
6
Worktop
1
1
1
Power bar
1
1
1
Tablet Stand
1
1
1
(2) Parts list:
Parts
Picture
Reference
60”
72”
90”
Workbench
Workbench
Workbench
#M8 * 60 HEX SCREW
20
20
20
#M8 HEX NUTS
12
12
12
#M8 BUTTER FLY NUT
8
8
8
#M6 * 25 SELF-
TAPPING SCREWS
10
10
10
#M3*45-GRAD SCREW
4
4
4
#M3- HEX NUTS
4
4
4
Assembly
1. Assemble the Frame
Select one bottom supporting frame (A) and one upper supporting frame (B) and lay them opposite one another on the floor.
2. Joine the frame and side beam
Joint the supporting frame, with 2 side support beams, with the supplied #M8 hex bolts and lock washers and NUTS.
3. Attach the Wood top:
Place the frame within the marked boundary and attach the top
with the supplied #M6 x1” wood screws in the 6 locations provided.
4. Slide the tray
Slide the tray down over the screws and tighten with a screwdriver to secure the tray to the workbench, and insert tray
dividers locations. See Figure 4
5. Assemble the power bar
Screw the powder bar in to the short side of the upper supporting beam
(The end)
/
