Page is loading ...
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com
iPad™ IPM-200 Mounting Frame Installation Instructions
9531-056-011-00
Parts List
IPM-200
IPM-200
(Qty 1)
M5 Security Allen Wrench
(Qty 1)
3130 East Miraloma Avenue
Anaheim, CA 92806 USA
USA and Canada
Phone: 1.800.368.9700
Fax: 1.800.832.4888
Other Locations – Phone: (001).714.632.7100; Fax: (001).714.632.1044 ©Premier Mounts 2011
The IPM-200 open mounting frame securely holds the Apple iPad™ or
iPad2™ (not included) in place and gives access to all iPad™ controls
and connections. It fastens easily to any of Premier Mounts’ wall or
table mounts (sold separately) using the VESA 100x100mm mounting
pattern, allowing tilt, rotation, height and/or directional adjustments.
Lock-It™ security hardware is included.
• All trademarks are the property of the respective trademark owners.
Step 1
Are you installing an original
iPad™ or iPad2™ to the
IPM-200?
If an original iPad™, remove
the corner felt pads on the
IPM-200. Then continue to
step 2 below.
If an iPad2™, continue to
step 2 below.
Step 2
Step 3
➊
Adjust the arms on the IPM-200
so that the iPad™ ts snuggly
inside the mount (Figure 1).
➋
Tighten the two (2) pre-installed
Phillips screws on the back of
the IPM-200 to secure the arms
(Figure 2).
➊
Extend the arms of the IPM-200.
➋
Insert the iPad™ in the IPM-200.
Each arm of the IPM-200 should
t over a corner of the iPad™.
M4 x 8mm Security Screw
(Qty 4)
Remove if using original iPad™
Remove if using original iPad™
Mounting tab on IPM-200
Step 4
Use the M5 security Allen wrench
and four (4) M4 x 8mm security
screws to attach the IPM-200 to any
100x100mm VESA mount.
Follow the installation
instructions included with the
VESA mount.
AM50S-B mount shown for illustration
purposes only.
Figure 1
Figure 2
Phillips screws
A A
A
A
A = 100x100mm
VESA mounting point
/