2. Computers & electronics
  3. Computers
  4. Tablets
  5. Tablet cases
  6. Premier Mounts
  7. IPM-500

Premier Mounts IPM-500 Installation guide

  • Hello! I've reviewed the Installation Instructions for the Premier Mounts IPM-500 Mounting Frame. This frame is designed to securely hold an iPad or iPad2 and offers 360-degree rotation. The document details the installation process including mounting the wall plate and securing the iPad within the frame. I'm ready to answer any questions you may have about the product or its installation!
  • What devices are compatible with the IPM-500?
    Does the IPM-500 provide access to all iPad controls and connections?
    Can the IPM-500 rotate?
Installation Instructions Visit the Premier Mounts website at http://www.mounts.com
iPad™ IPM-500 Mounting Frame Installation Instructions
9531-056-041-00
Parts List
IPM-500
IPM-500
(Qty 1)
3130 East Miraloma Avenue
Anaheim, CA 92806 USA
USA and Canada
Phone: 1.800.368.9700
Fax: 1.800.832.4888
Other Locations – Phone: (001).714.632.7100; Fax: (001).714.632.1044 ©Premier Mounts 2011
The IPM-500 open mounting frame securely holds the Apple iPad™ or
iPad2™ (not included) in place and gives access to all iPad™ controls
and connections. Its removeable wall mount plate may be installed on
any single stud surface, and provides 360° rotation for landscape or
portrait placement.
• All trademarks are the property of the respective trademark owners.
Step 3
Are you installing an original
iPad™ or iPad2™ to the
IPM-500?
If an original iPad™, remove
the corner felt pads on the
IPM-500. Then continue to
step 4 below.
If an iPad2™, continue to
step 4 below.
Step 4
➊Extend the arms of the IPM-500.
➋Insert the iPad™ in the IPM-500.
Each arm of the IPM-500 should
t over a corner of the iPad™.
Remove if using original iPad™
Remove if using original iPad™
#8 x 1¼” Wood Screw
(Qty 2)
Step 1
Remove the wall plate from the
IPM-500.
Step 2
Use two (2) #8 x 1¼” wood screws
to attach the wall plate to a single
wood stud.
#8 x 1¼” Wood Screw
Page 2 Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
IPM-500
Step 5
➊Adjust the arms on the IPM-500
so that the iPad™ ts snuggly
inside the mount (Figure 1).
➋Tighten the two (2) pre-installed
Phillips screws on the back of
the IPM-500 to secure the arms
(Figure 2).
Step 6
➊Insert the IPM-500 into the wall
plate.
➋Rotate the mount to the desired
landscape or portrait position.
➌Tighten the two (2) pre-installed
M4 x 16mm pan combo screws
on the sides of the wall plate.
Mounting tab on IPM-500
Figure 1
Figure 2
Phillips screws
IPM-500 Installation Instructions (cont’d)
/