LED String Light
Instruction Manual
Thank you for your purchase.
Please contact us if you have any questions.
SAFETY WARNINGS
1. Keep the product out of reach for babies, children and pets in case
of fire, burns and electric shock.
2. Do not turn unwrapped or messy lights on as the accumulative heat
couldn't give out promptly and cause fire.
3. Do not place the string lights near gas, heaters, fireplaces, candles
or other ignitions. It is forbidden to be put on carpets, curtains and
other furniture or cover it with cloth, paper, and any other material while
the power is on.
4. Do not secure wires with staples, nails or sharp hooks. Please close
doors or windows carefully to prevent insulating layer damage.
5. Do not hang ornaments on the product as they the wires may break
off due to heavy weight.
DAILY USE AND MAINTENANCE
Inspect the product carefully before using. Discard the product if
there is any damage to the wires or lights.
This LED String Light is rated 2.4 Watts. Connect other decorative
outfits up to 216 Watts in total. Do not overload during use.
This product adopts overload protection (fuse). A blown fuse
indicates an overload or short circuit situation. If the fuse blows,
unplug the string lights and any additional strings that connected to
it. Replace the fuse according to the replacement instruction, then
check if it works. If the replacement fuse blows again, it may show
short circuit and you should discard the product.
Do not use it with bulbs missing and missing bulbs should be added
immediately.
When hanging on a tree, the tree should be well secured and stable.
After use, remove the product gently to avoid any scratches to the
wires or lights.
Do not perform any troubleshooting or maintenance for broken
lamps when the power is on.
When not in use, unplug the product, keep it in a cool dry place and
avoid direct sun exposure.
REPLACEMENT INSTRUCTION
1. Unplug the product before changing fuses. Grasp the plug and
remove it from the outlet instead of pulling the cord.
2. To avoid risk of fire, do not replace attachment plug. Discard product
if the attachment plug is damaged.
Fuse Replacement
a. Open the fuse cover on the plug and remove the burn fuse.
b. Install the new 3 Amp 125 Volt fuse.
c. Close fuse cover. Make sure the fuse is fully covered by the lid.
One-year Limited Warranty
We warrant this product to be free from defects in material and
workmanship for a period of one year from the date of purchase.
Warranty will be void if damage is due to misuse or improper installa-
tion. Please contact us if you have any questions.
Specifications:
Bulb Quantity: 50 pcs
Bulb Spacing: 7 7/8'' (20 cm)
Lead Length: 0.67ft
Lighted Length: 32.63ft
Total Length: 33.3ft
Input Voltage: 120VAC 60Hz
20 cm10 cm 10 cm
125V FUSE
USE ONLY
3A MAX.
125V FU SE
USE ONLY
3A M
AX.
TING SHEN
TS23
125V FU SE
USE ONLY
3A MAX.
