Determine if you need a left or right hand configuration. For instructional purposes this manual will show the
right hand configuration installation.
This product contains small items that could be a choking hazard if swallowed. Keep these items away from young children.
• Make sure these instructions are read and completely understood before attempting installation.
If you are unsure of any part of this installation, please contact a professional installer for assistance.
CAUTION
01
Determine Configuration
Installing Latch Assembly
Step 1: Close the gate and align latch (A) with the latch receiver (B). The latch (A) should be on the gate side
and the latch receiver (B) on the post side. Ensure the entire assembly is level and aligned properly.
Mark the 4 holes on the latch (A) and the 3 holes on the latch receiver (B).
Step 2: Drill 7 pilot holes using a power drill and a 1/8" (3mm) drill bit.
Do not drill all the way through the gate or post.
Step 3: Tighten the 7 screws "clockwise" using a phillips head screwdriver.
A (1x) B (1x) C (7x)
B088XWMM5L
Gate Hatch - 5.5-Inch, Black
Aldaba para Puertas - 5.5 Pulgadas (14 cm), Negro
Clenche de Grille - 5,5 Po, Noir
1/8" (3 mm)
RH
LH
A
B
A
B
NOTICE
Page is loading ...
Page is loading ...
/
