B088XR9TJW
Gate Latch - Flush-Mounted, 6-Inch, Black
Cerrojo para Puertas - Montaje al Ras,
6 Pulgadas (15.2 cm), Negro
Clenche de Grille - Encastrée, 6 Po, Noir
Determine if you need a left or right hand configuration. The latch assembly comes preconfigured for
right hand installations. For right hand configurations skip to step 1 on page 02.
Step 1: Remove bolt "counterclockwise" with 17/32 in. (13mm) wrench.
Step 2: Remove spring from mounting plate. Rotate latch.
This product contains small items that could be a choking hazard if swallowed. Keep these items away from young children.
• Make sure these instructions are read and completely understood before attempting installation.
If you are unsure of any part of this installation, please contact a professional installer for assistance.
A (1x) B (1x) C (4x)
CAUTION
01
Determine Configuration
Changing to Left Hand Configuration
Step 3: Flip entire assembly. Reinstall bolt and tighten "clockwise". Reattach spring.
1/8" (3 mm)
RH
LH
02
Installing Latch Assembly
Installing Keeper bar
Step 1: Using a pencil, mark the two holes on the inside edge of the fence post for the mounting plate.
Step 2: Drill 2 pilot holes using a power drill and a 1/8" (3mm) drill bit.
Step 2: Drill 2 pilot holes using a power drill and a 1/8" (3mm) drill bit.
Step 1: With gate closed, inset the keeper bar (B) into the latch assembly.
Mark the two holes with a pencil.
Step 3: To install the latch assembly, tighten the 2 lag bolts "clockwise" using a 17/32" (13mm) wrench.
You may also use a 17/32" (13mm) socket on your power drill. Do not over-tighten.
Step 3: To install the keeper bar, tighten the 2 lag bolts "clockwise" using a 17/32" (13mm) wrench.
You may also use a 17/32" (13mm) socket on your power drill. Do not over-tighten.
B
A
Page is loading ...
Page is loading ...
/
