The Great Outdoors 72653-172 User manual

Brand: The Great Outdoors

Model: 72653-172

Type: User manual

The Great Outdoors 72653-172 is a light fixture designed for both indoor and outdoor use. It is easy to install and can be mounted on a ceiling or wall. The fixture has a vintage-style design and comes with a clear glass shade. It is recommended to use a T10 vintage bulb with a length of 300mm for optimal light output. The fixture is rated for a maximum wattage of 60W. It is important to note that the fixture does not come with a bulb, so you will need to purchase one separately.

INSTALLATION INSTRUCTIONS

For item#72653-172 (New. 04/26/2018)

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig.1

Fig. 3

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker and remove old

fixture, including the mounting hardware.

2. Carefully remove the fixture from the carton and check

that all parts are included as shown in the illustration.

3. Attach mounting plate (A) using the mounting screws (B)

(Size: #8-32N*L0.5”) to the junction box. The side of the

mounting plate marked “GND” must face out.

CONNECTING THE WIRES (Fig. 2)

4. At this point, connect the electrical wires as shown in

Fig. 2, making sure that all wire connectors are secured.

If your outlet box has a ground wire (green or bare

copper), connect the fixture’s ground wire to it.

Otherwise, connect the fixture’s ground wire directly to

the mounting plate using the green screw provided. After

wires are connected, tuck them carefully inside the

junction box.

FINISHING THE INSTALLATION (Fig.1)

5. Place the fixture body (D) over the mounting plate (A),

fastens with screws (C).

6. To prevent moisture from entering the outlet box and

causing a shortage, use clear caulking (i.e.

Indoor/Outdoor silicone sealant) to outline the outside of

fixture back plate where it meets the wall leaving a space

at the bottom to allow moisture a means to escape

(Fig.3).

7. Install light bulb(s) (F) (Not included) in accordance with

the fixture’s specification. Recommend to use a T10

vintage bulb with properly length for light output evenly,

Recommend to use a 300mm length for 72653-172.

( (DO NOT EXCEED THE MAXIMUM WATTAGE

RATING!) (NE PAS DEPASSER LA PUISSANCE

NOMINALE MAXIMALE!).

8. Put the glass shade (G) over the socket (E) and turn to

secure it to the fixture.

Your installation is now complete. Return power to the

outlet box and test the fixture.

Note: Illustration (Fig. 1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

LA-2920E

Fig.2

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green or

Bare

Copper

(Ground)

Set# A-021-117211

- Circular Strap

- Ground Screw

- Mounting Screw*2

CAULKING

BACKPLATE

The Great Outdoors 72653-172 User manual

The Great Outdoors 72653-172 User manual

The Great Outdoors 72653-172 User manual

Related papers